Skip to contentSkip to conversation

Trying to understand alsa

DISCUSSION Jonathan Andrews 1 participant 1 message Jan 12, 2012

lore
Share & tools
lore
#0 lore raw
Quoted 8 lines · Fons Adriaensen
Quoted 5 lines · Jonathan Andrews

What I want to do is tell ALSA to hold a buffer of 3 of my packets (3 x 1024Bytes, thats 512 x 16 bit samples) while I feed extra packets (1K Byte, 512 samples per buffer) in for playback. The packets are arriving at roughly the correct rate, I just need a buffer to iron out any jitter in network transmit, do I have to do this myself ?

Quoted 4 lines

Unless data is arriving on average at *exactly* the sample rate of the ALSA device your buffering will sooner or later underrun or overrun. ALSA itself can't handle this use case, it requires adaptive resampling and it's not easy.

I'm assuming alsa is holding 3k bytes for me and im writing 1k byte chunks, so if the audio has not been refreshed by 3 chunks (70ms) then I should throw it away as its no longer 'real time'

At the moment i would happy just to throw away packets that would cause an overrun. I just wish i could convince alsa to buffer for me .... ho hum ...

with pulse I just did this to set up 'some sort of buffer length' with 'some sort of pre buffering before play' interval. Its a bit hacky at the moment but seems to work.

    pa_buffer_attr  paattr;
    int buflen=sizeof(audio);
    paattr.tlength = buflen * 4;                                                                // Playback only, target length of the buffer (was *2)
    paattr.minreq = buflen;
    paattr.fragsize = buflen;
    paattr.prebuf = buflen * 6;                                                                 // How much data pulse holds before it starts playing (was *4)
    paattr.maxlength = buflen * 8;                                                              // playback pipeline N samples deep (was *4)

Im looking for alsa equivalent.

Thanks,
Jon