mfd: Move MFD_TPS65090 and TPS65911_COMPARATOR Kconfig entries to proper location

-----Original Message-----
From: Axel Lin [mailto:[email protected]]
Sent: Thursday, March 22, 2012 7:42 AM
To: [email protected]
Cc: Jorge Eduardo Candelaria; Venu Byravarasu; Samuel Ortiz
Subject: [PATCH] mfd: Move MFD_TPS65090 and TPS65911_COMPARATOR Kconfig entries to proper location

Group all TPSxxxx drivers together and sort by alphabetical order.

Signed-off-by Axel Lin <[email protected]>

---
 drivers/mfd/Kconfig |   30 +++++++++++++++---------------
 1 files changed, 15 insertions(+), 15 deletions(-)

drivers/mfd/Kconfig +15 -16

index 29f463c..f9e0353 100644
@@ -143,6 +143,18 @@ config TPS6507X
 	  This driver can also be built as a module.  If so, the module
 	  will be called tps6507x.
 
+config MFD_TPS65090
+	bool "TPS65090 Power Management chips"
+	depends on I2C=y && GENERIC_HARDIRQS
+	select MFD_CORE
+	select REGMAP_I2C
+	help
+	  If you say yes here you get support for the TPS65090 series of
+	  Power Management chips.
+	  This driver provides common support for accessing the device,
+	  additional drivers must be enabled in order to use the
+	  functionality of the device.
+
 config MFD_TPS65217
 	tristate "TPS65217 Power Management / White LED chips"
 	depends on I2C

@@ -182,6 +194,9 @@ config MFD_TPS65910
 	  if you say yes here you get support for the TPS65910 series of
 	  Power Management chips.
 
+config TPS65911_COMPARATOR
+	tristate
+
 config MFD_TPS65912
 	bool
 	depends on GPIOLIB

@@ -825,21 +840,6 @@ config MFD_PM8XXX_IRQ
 	  This is required to use certain other PM 8xxx features, such as GPIO
 	  and MPP.
 
-config TPS65911_COMPARATOR
-	tristate
-
-config MFD_TPS65090
-	bool "TPS65090 Power Management chips"
-	depends on I2C=y && GENERIC_HARDIRQS
-	select MFD_CORE
-	select REGMAP_I2C
-	help
-	  If you say yes here you get support for the TPS65090 series of
-	  Power Management chips.
-	  This driver provides common support for accessing the device,
-	  additional drivers must be enabled in order to use the
-	  functionality of the device.
-
 config MFD_AAT2870_CORE
 	bool "Support for the AnalogicTech AAT2870"
 	select MFD_CORE
--

1.7.5.4