Skip to contentSkip to conversation

Intel N 1030 desn't connect to AP with WPA2 | Linux 3.4.2

DISCUSSION Mariusz Fik 2 participants 3 messages Jun 26, 2012 – Jul 2, 2012

lore
Share & tools
lore
#0 lore raw

Hi,

I installed openSUSE 12.2 Beta 2 with linux 3.4.2 recently and my wifi card has problems with connecting to AP with WPA2. Hardware I have:
| 02:00.0 Network controller [0280]: Intel Corporation Centrino Wireless-N 1030 [8086:008a] (rev 34)

After boot I connected to my AP and wifi worked fine. After few seconds connection was disconnected and nm asked me again for password. Every try of connection was unsuccessful since now. dmesg, in the time of trying to connect, gives me:

| [  434.134710] wlan0: authenticate with 00:22:15:0b:55:a3
| [  434.143822] wlan0: direct probe to 00:22:15:0b:55:a3 (try 1/3)
| [  434.344492] wlan0: direct probe to 00:22:15:0b:55:a3 (try 2/3)
| [  434.545185] wlan0: send auth to 00:22:15:0b:55:a3 (try 3/3)
| [  434.745882] wlan0: authentication with 00:22:15:0b:55:a3 timed out
| [  434.747111] iwlwifi 0000:02:00.0: ACTIVATE a non DRIVER active station id 

0 addr 00:22:15:0b:55:a3

Full dmesg is available here: http://wklej.org/hash/1dc3164fa7/

Any hints about solving it?

Signature · 4 lines
Pozdrawiam / Best regards,
Mariusz Fik
openSUSE Community Member
GPG: 5FCE 7241 B3B9 32FD 455B C30E 42D6 6C88 9E83 7C3D
#1 lore raw
Quoted 11 lines · Mariusz Fik

Hi,

I installed openSUSE 12.2 Beta 2 with linux 3.4.2 recently and my wifi card has problems with connecting to AP with WPA2. Hardware I have:
| 02:00.0 Network controller [0280]: Intel Corporation Centrino Wireless-N 1030 [8086:008a] (rev 34)

After boot I connected to my AP and wifi worked fine. After few seconds connection was disconnected and nm asked me again for password. Every try of connection was unsuccessful since now. dmesg, in the time of trying to connect, gives me:

Quoted 5 lines
| [  434.134710] wlan0: authenticate with 00:22:15:0b:55:a3
| [  434.143822] wlan0: direct probe to 00:22:15:0b:55:a3 (try 1/3)
| [  434.344492] wlan0: direct probe to 00:22:15:0b:55:a3 (try 2/3)
| [  434.545185] wlan0: send auth to 00:22:15:0b:55:a3 (try 3/3)
| [  434.745882] wlan0: authentication with 00:22:15:0b:55:a3 timed out

You're probably running into the TX power issue, that is fixed in 3.4.4:
http://git.kernel.org/?p=linux/kernel/git/stable/linux-stable.git;a=commitdiff;h=75862961e9b445a9bfce25b9da70ef930a857762

Quoted 2 lines

| [ 434.747111] iwlwifi 0000:02:00.0: ACTIVATE a non DRIVER active station id 0 addr 00:22:15:0b:55:a3

I have a separate fix for this, but I think it's a red herring and probably doesn't cause your problem.

johannes

#2 lore raw

Dnia wtorek, 26 czerwca 2012 18:53:02 Johannes Berg pisze:

Quoted 25 lines · Mariusz Fik
Quoted 15 lines

Hi,

I installed openSUSE 12.2 Beta 2 with linux 3.4.2 recently and my wifi card

has problems with connecting to AP with WPA2. Hardware I have:
| 02:00.0 Network controller [0280]: Intel Corporation Centrino Wireless-N

1030 [8086:008a] (rev 34)

After boot I connected to my AP and wifi worked fine. After few seconds connection was disconnected and nm asked me again for password. Every try of connection was unsuccessful since now. dmesg, in the time of trying to>
connect, gives me:

Quoted 5 lines
| [  434.134710] wlan0: authenticate with 00:22:15:0b:55:a3
| [  434.143822] wlan0: direct probe to 00:22:15:0b:55:a3 (try 1/3)
| [  434.344492] wlan0: direct probe to 00:22:15:0b:55:a3 (try 2/3)
| [  434.545185] wlan0: send auth to 00:22:15:0b:55:a3 (try 3/3)
| [  434.745882] wlan0: authentication with 00:22:15:0b:55:a3 timed out

You're probably running into the TX power issue, that is fixed in 3.4.4:
http://git.kernel.org/?p=linux/kernel/git/stable/linux-stable.git;a=commitdi
ff;h=75862961e9b445a9bfce25b9da70ef930a857762

Quoted 8 lines
Quoted 3 lines

| [ 434.747111] iwlwifi 0000:02:00.0: ACTIVATE a non DRIVER active | station id>
0 addr 00:22:15:0b:55:a3

I have a separate fix for this, but I think it's a red herring and probably doesn't cause your problem.

johannes

I updated kernel to 3.4.4 and it fixed my issue.
Thanks a lot.

Signature · 4 lines
Pozdrawiam / Best regards,
Mariusz Fik
openSUSE Community Member
GPG: 5FCE 7241 B3B9 32FD 455B C30E 42D6 6C88 9E83 7C3D