MD: Fix typos in MD documentation
Subsystems (2)
PATCH 1/1 MD: Fix typos in MD documentation
MD: Fix some typos/grammer in MD documentation
Documentation/md.txt +8 -8
@@ -119,7 +119,7 @@ device to add. The array is started with the RUN_ARRAY ioctl. Once started, new devices can be added. They should have an -appropriate superblock written to them, and then passed be in with +appropriate superblock written to them, and then be passed in with ADD_NEW_DISK. Devices that have failed or are not yet active can be detached from an
@@ -131,7 +131,7 @@ Specific Rules that apply to format-0 su ------------------------------------------------------------- An array can be 'created' by describing the array (level, chunksize -etc) in a SET_ARRAY_INFO ioctl. This must has major_version==0 and +etc) in a SET_ARRAY_INFO ioctl. This must have major_version==0 and raid_disks != 0. Then uninitialized devices can be added with ADD_NEW_DISK. The
@@ -426,7 +426,7 @@ Each directory contains: offset This gives the location in the device (in sectors from the start) where data from the array will be stored. Any part of - the device before this offset us not touched, unless it is + the device before this offset is not touched, unless it is used for storing metadata (Formats 1.1 and 1.2). size
@@ -440,7 +440,7 @@ Each directory contains: When the device is not 'in_sync', this records the number of sectors from the start of the device which are known to be correct. This is normally zero, but during a recovery - operation is will steadily increase, and if the recovery is + operation it will steadily increase, and if the recovery is interrupted, restoring this value can cause recovery to avoid repeating the earlier blocks. With v1.x metadata, this value is saved and restored automatically.
@@ -468,7 +468,7 @@ Each directory contains: -An active md device will also contain and entry for each active device +An active md device will also contain an entry for each active device in the array. These are named rdNN
@@ -482,7 +482,7 @@ will show 'in_sync' on every line. -Active md devices for levels that support data redundancy (1,4,5,6) +Active md devices for levels that support data redundancy (1,4,5,6,10) also have sync_action
@@ -494,7 +494,7 @@ also have failed/missing device idle - nothing is happening check - A full check of redundancy was requested and is - happening. This reads all block and checks + happening. This reads all blocks and checks them. A repair may also happen for some raid levels. repair - A full check and repair is happening. This is
@@ -522,7 +522,7 @@ also have degraded This contains a count of the number of devices by which the - arrays is degraded. So an optimal array with show '0'. A + arrays is degraded. So an optimal array will show '0'. A single failed/missing drive will show '1', etc. This file responds to select/poll, any increase or decrease in the count of missing devices will trigger an event.
Am Donnerstag, den 07.03.2013, 16:19 -0600 schrieb Jonathan Brassow:
Quoted 6 lines
MD: Fix some typos/grammer in MD documentation
Signed-off-by Jonathan Brassow <[email protected]>Index:
linux-upstream/Documentation/md.txt
===================================================================
Did you use git format-patch? If not, hopefully this patch can be easily applied with git am.
[…]
Thanks,
Paul
Quoted 10 lines · Paul Menzel
Am Donnerstag, den 07.03.2013, 16:19 -0600 schrieb Jonathan Brassow:
Quoted 6 lines
MD: Fix some typos/grammer in MD documentation
Signed-off-by Jonathan Brassow <[email protected]>Index:
linux-upstream/Documentation/md.txt
===================================================================Did you use
git format-patch? If not, hopefully this patch can be easily applied withgit am.
No. I generally use 'quilt' and insert the patches into my email client. If it's better to do something else, let me know and I will do that.
brassow
Quoted 14 lines · Brassow Jonathan
Quoted 10 lines · Paul Menzel
Am Donnerstag, den 07.03.2013, 16:19 -0600 schrieb Jonathan Brassow:
Quoted 6 lines
MD: Fix some typos/grammer in MD documentation
Signed-off-by Jonathan Brassow <[email protected]>Index:
linux-upstream/Documentation/md.txt
===================================================================Did you use
git format-patch? If not, hopefully this patch can be easily applied withgit am.
Quoted 8 lines
No. I generally use 'quilt' and insert the patches into my email client. If it's better to do something else, let me know and I will do that.
brassow
--
To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Take a look at git-format-patch and git-send-email. :)
Generally this is preferred as the patches can be applied automatically via git-am
Signature · 2 lines
CTO | Orion Virtualisation Solutions | www.orionvm.com.au Phone: 1300 56 99 52 | Mobile: 0428 754 846
Quoted 24 lines · On Sat, 9 Mar 2013 04:35:16 +1100 Joseph Glanville…
Quoted 14 lines · Brassow Jonathan
Quoted 10 lines · Paul Menzel
Am Donnerstag, den 07.03.2013, 16:19 -0600 schrieb Jonathan Brassow:
Quoted 6 lines
MD: Fix some typos/grammer in MD documentation
Signed-off-by Jonathan Brassow <[email protected]>Index:
linux-upstream/Documentation/md.txt
===================================================================Did you use
git format-patch? If not, hopefully this patch can be easily applied withgit am.Quoted 8 lines
No. I generally use 'quilt' and insert the patches into my email client. If it's better to do something else, let me know and I will do that.
brassow
--
To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Quoted 5 lines
Take a look at git-format-patch and git-send-email. :)
Generally this is preferred as the patches can be applied automatically via git-am
I had no difficulty applying the patch with "git am".
Jon: feel free to use quilt if that works for you. If it ever causes problems, I'll let you know.
Patch applied -thanks,
NeilBrown