TPM: STMicroelectronics st33 driver SPI
Subsystems (6)
PATCH 1/1 TPM: STMicroelectronics st33 driver SPI
* STMicroelectronics version 1.2.0, Copyright (C) 2010
* STMicroelectronics comes with ABSOLUTELY NO WARRANTY.
* This is free software, and you are welcome to redistribute it
* under certain conditions.
This is the driver for TPM chip from ST Microelectronics.
If you have a TPM security chip from STMicroelectronics working with an I2C/SPI, in menuconfig or .config choose the tpm driver on device --> tpm and activate the protocol of your choice before compiling the kernel.
The driver will be accessible from within Linux.
Tested on linux x86/x64 and beagleboard REV B & XM REV C
Signed-off-by Mathias Leblanc <[email protected]>
--- arch/arm/mach-omap2/board-omap3beagle.c | 40 ++ drivers/char/tpm/Kconfig | 10 + drivers/char/tpm/Makefile | 1 + drivers/char/tpm/tpm_spi_stm_st33.c | 1116 +++++++++++++++++++++++++++++++ drivers/char/tpm/tpm_spi_stm_st33.h | 75 ++ include/linux/spi/tpm_spi_stm_st33.h | 46 ++ 6 files changed, 1287 insertions(+), 0 deletions(-) create mode 100644 drivers/char/tpm/tpm_spi_stm_st33.c create mode 100644 drivers/char/tpm/tpm_spi_stm_st33.h create mode 100644 include/linux/spi/tpm_spi_stm_st33.h
arch/arm/mach-omap2/board-omap3beagle.c +40 -0
@@ -46,6 +46,11 @@#include <video/omap-panel-tfp410.h> #include <linux/platform_data/mtd-nand-omap2.h> +#ifdef CONFIG_TCG_ST33_SPI +#include <linux/spi/tpm_spi_stm_st33.h> +#include <linux/spi/spi.h> +#endif /* CONFIG_TCG_ST33_SPI */ +#include "common.h" #include "omap_device.h" #include "gpmc.h"
@@ -375,6 +380,26 @@ static struct i2c_board_info __initdata beagle_i2c_eeprom[] = { }, }; +#if definedCONFIG_TCG_ST33_I2C || definedCONFIG_TCG_ST33_SPI +static struct st33zp24_platform_data tpm_data = { + .io_serirq =136 , + .io_lpcpd =143 , +}; +#endif + +#ifdef CONFIG_TCG_ST33_SPI +static struct spi_board_info tpm_st33_spi_board_info[] = { + { + .modalias =TPM_ST33_SPI , + .max_speed_hz =10000000 , + .bus_num =4 , + .chip_select =0 , + .mode =SPI_MODE_0 , + .platform_data = &tpm_data, + }, +}; +#endif +static int __init omap3_beagle_i2c_init (void ) { omap3_pmic_get_config(&beagle_twldata,
@@ -556,6 +581,20 @@ static void __init omap3_beagle_init(void)omap_mux_init_signal ("sdrc_cke0" ,OMAP_PIN_OUTPUT );omap_mux_init_signal ("sdrc_cke1" ,OMAP_PIN_OUTPUT ); +#if definedCONFIG_TCG_ST33_I2C || definedCONFIG_TCG_ST33_SPI +omap_mux_init_gpio (tpm_data.io_serirq,OMAP_PIN_INPUT ); +omap_mux_init_gpio (tpm_data.io_lpcpd,OMAP_PIN_OUTPUT ); +#endif + +#ifdef CONFIG_TCG_ST33_SPI +omap_mux_init_signal ("mcspi4_clk" ,OMAP_PIN_INPUT ); +omap_mux_init_signal ("mcspi4_cs0" ,OMAP_PIN_OUTPUT ); +omap_mux_init_signal ("mcspi4_simo" ,OMAP_PIN_OUTPUT ); +omap_mux_init_signal ("mcspi4_somi" ,OMAP_PIN_INPUT ); + +spi_register_board_info (tpm_st33_spi_board_info, +ARRAY_SIZE (tpm_st33_spi_board_info)); +#endif +pwm_add_table (pwm_lookup,ARRAY_SIZE (pwm_lookup)); }
drivers/char/tpm/Kconfig +10 -0
@@ -91,4 +91,14 @@ config TCG_ST33_I2C To compile this driver as a module, choose M here; the module will be called tpm_stm_st33_i2c. +config TCG_ST33_SPI + tristate "STMicroelectronics ST33 SPI" + depends on SPI + depends on GPIOLIB + ---help--- + If you have a TPM security chip from STMicroelectronics working with + an SPI bus say Yes and it will be accessible from within Linux. + To compile this driver as a module, choose M here; the module will be + called tpm_stm_st33_spi. + endif # TCG_TPM
drivers/char/tpm/Makefile +1 -0
@@ -18,3 +18,4 @@ obj-$(CONFIG_TCG_ATMEL) += tpm_atmel.o obj-$(CONFIG_TCG_INFINEON) += tpm_infineon.o obj-$(CONFIG_TCG_IBMVTPM) += tpm_ibmvtpm.o obj-$(CONFIG_TCG_ST33_I2C) += tpm_i2c_stm_st33.o +obj-$(CONFIG_TCG_ST33_SPI) += tpm_spi_stm_st33.o
drivers/char/tpm/tpm_spi_stm_st33.c new file +1116 -0
1,116 lines not on this page · raw message
drivers/char/tpm/tpm_spi_stm_st33.h new file +75 -0
75 lines not on this page · raw message
include/linux/spi/tpm_spi_stm_st33.h new file +46 -0
46 lines not on this page · raw message
Signature · 1 line
1.7.1