iio: adc: add driver for MCP3204/08 12-bit ADC
PATCH v3 1/1 iio: adc: add driver for MCP3204/08 12-bit ADC
This adds support for Microchip's 12 bit AD converters MCP3204 and MCP3208. These chips communicates over SPI and supports single-ended and pseudo-differential configurations.
Cc Jonathan Cameron <[email protected]>
Cc Lars-Peter Clausen <[email protected]>
Signed-off-by Oskar Andero <[email protected]>
--- drivers/iio/adc/Kconfig | 10 ++ drivers/iio/adc/Makefile | 1 + drivers/iio/adc/mcp320x.c | 258 ++++++++++++++++++++++++++++++++++++++++++++++ 3 files changed, 269 insertions(+) create mode 100644 drivers/iio/adc/mcp320x.c
drivers/iio/adc/Kconfig +10 -0
@@ -133,6 +133,16 @@ config MAX1363 max11646, max11647) Provides direct access via sysfs and buffered data via the iio dev interface. +config MCP320X + tristate "Microchip Technology MCP3204/08" + depends on SPI + help + Say yes here to build support for Microchip Technology's MCP3204 or + MCP3208 analog to digital converter. + + This driver can also be built as a module. If so, the module will be + called mcp320x. + config TI_ADC081C tristate "Texas Instruments ADC081C021/027" depends on I2C
drivers/iio/adc/Makefile +1 -0
@@ -14,6 +14,7 @@ obj-$(CONFIG_AT91_ADC) += at91_adc.o obj-$(CONFIG_EXYNOS_ADC) += exynos_adc.o obj-$(CONFIG_LP8788_ADC) += lp8788_adc.o obj-$(CONFIG_MAX1363) += max1363.o +obj-$(CONFIG_MCP320X) += mcp320x.o obj-$(CONFIG_TI_ADC081C) += ti-adc081c.o obj-$(CONFIG_TI_AM335X_ADC) += ti_am335x_adc.o obj-$(CONFIG_VIPERBOARD_ADC) += viperboard_adc.o
drivers/iio/adc/mcp320x.c new file +258 -0
258 lines not on this page · raw message
Signature · 1 line
1.8.1.5
On 05/03/2013 10:55 AM, Oskar Andero wrote:
[...]
drivers/iio/adc/mcp320x.c line 36
Quoted 11 lines
drivers/iio/adc/mcp320x.c new file +11
-0+ +struct mcp320x { +struct spi_device *spi; +struct spi_message msg; +struct spi_transfer transfer[2 ]; + +u8 tx_buf; +u8 rx_buf[2 ]; + +struct regulator *reg; +unsigned int ref_mv;
ref_mv looks unused.
Quoted 4 lines
drivers/iio/adc/mcp320x.c new file +4
-0+ +struct mutex lock; +}; +
[..]
Quoted 2 lines
(quoted diff) +2
-0+static int mcp320x_probe(struct spi_device *spi) +{
[...]
drivers/iio/adc/mcp320x.c line 206
Quoted 4 lines
drivers/iio/adc/mcp320x.c new file +4
-0+ + ret =regulator_enable (adc->reg); +if (ret <0 ) + goto reg_free;
You shouldn't disable the regulator if enabling it failed.
Quoted 17 lines
drivers/iio/adc/mcp320x.c new file +17
-0+ +mutex_init (&adc->lock); + + ret =iio_device_register (indio_dev); +if (ret <0 ) + goto reg_free; + +return 0 ; + +reg_free: +regulator_disable (adc->reg); +regulator_put (adc->reg); +iio_free: +iio_device_free (indio_dev); + +return ret; +}
[...]