ASoC: codecs: adau1701: add DT bindings
Subsystems (4)
PATCH v2 1/1 ASoC: codecs: adau1701: add DT bindings
Apart from pure matching, the bindings also support setting the the reset gpio line.
Signed-off-by Daniel Mack <[email protected]>
---
Lars,
thanks for the quick review. Here's v2 of that patch.
.../devicetree/bindings/sound/adi,adau1701.txt | 23 ++++++++++++++ sound/soc/codecs/adau1701.c | 35 +++++++++++++++++++++- 2 files changed, 57 insertions(+), 1 deletion(-) create mode 100644 Documentation/devicetree/bindings/sound/adi,adau1701.txt
Documentation/devicetree/bindings/sound/adi,adau1701.txt new file +23 -0
@@ -0,0 +1,23 @@ +Analog Devices ADAU1701 + +Required properties: + + - compatible: Should contain "adi,adau1701" + - reg: The i2c address. Value depends on the state of ADDR0 + and ADDR1, as wired in hardware. + +Optional properties: + + - reset-gpio: A GPIO spec to define which pin is connected to the + chip's !RESET pin. If specified, the driver will + assert a hardware reset at probe time. + +Examples: + + i2c_bus { + adau1701@34 { + compatible = "adi,adau1701"; + reg = <0x34>; + reset-gpio = <&gpio 23 0>; + }; + };
sound/soc/codecs/adau1701.c +34 -1
@@ -13,6 +13,9 @@#include <linux/i2c.h> #include <linux/delay.h> #include <linux/slab.h> +#include <linux/of.h> +#include <linux/of_gpio.h> +#include <linux/of_device.h> #include <sound/core.h> #include <sound/pcm.h> #include <sound/pcm_params.h>
@@ -452,6 +455,14 @@ static struct snd_soc_dai_driver adau1701_dai = { .symmetric_rates = 1, }; +#ifdef CONFIG_OF +static const struct of_device_id adau1701_dt_ids[] = { + { .compatible ="adi,adau1701" , }, + { } +}; +MODULE_DEVICE_TABLE (of, adau1701_dt_ids); +#endif +static int adau1701_probe (struct snd_soc_codec *codec) {int ret;
@@ -494,12 +505,33 @@ static int adau1701_i2c_probe(struct i2c_client *client, const struct i2c_device_id *id) {struct adau1701 *adau1701; +struct device *dev = &client->dev; +int gpio_nreset = -EINVAL ;int ret; - adau1701 =devm_kzalloc (&client->dev,sizeof (*adau1701),GFP_KERNEL ); + adau1701 =devm_kzalloc (dev,sizeof (*adau1701),GFP_KERNEL );if (!adau1701)return -ENOMEM ; +if (dev->of_node) { + gpio_nreset =of_get_named_gpio (dev->of_node,"reset-gpio" ,0 ); +if (gpio_nreset <0 && gpio_nreset != -ENOENT ) +return gpio_nreset; + } + +if (gpio_is_valid (gpio_nreset)) { + ret =devm_gpio_request_one (dev, gpio_nreset,GPIOF_OUT_INIT_LOW , +"ADAU1701 Reset" ); +if (ret <0 ) +return ret; + +/* minimum reset time is 20ns */ +udelay (1 ); +gpio_set_value (gpio_nreset,1 ); +/* power-up time may be as long as 85ms */ +mdelay (85 ); + } +i2c_set_clientdata (client, adau1701); ret =snd_soc_register_codec (&client->dev, &adau1701_codec_drv, &adau1701_dai,1 );
@@ -522,6 +554,7 @@ static struct i2c_driver adau1701_i2c_driver = { .driver = { .name = "adau1701", .owner = THIS_MODULE, + .of_match_table = of_match_ptr(adau1701_dt_ids), }, .probe = adau1701_i2c_probe, .remove = adau1701_i2c_remove,
Signature · 1 line
1.8.1.4
Quoted 4 lines · Daniel Mack
Apart from pure matching, the bindings also support setting the the reset gpio line.
Signed-off-by Daniel Mack <[email protected]>
Thanks.
Quoted 2 lines · Daniel Mack
Apart from pure matching, the bindings also support setting the the reset gpio line.
Applied, thanks.