bonding: remove ifenslave.c from kernel source
Subsystems (3)
PATCH 1/1 bonding: remove ifenslave.c from kernel source
From: Cong Wang <[email protected]>
As Stephen proposed:
Since bonding supports configuration via iproute (netlink) and sysfs, I think it is time to purge the old ifenslave code out of Documentation/networking and update the documentation.
---
Documentation/networking/.gitignore +0 -1
@@ -1 +0,0 @@ -ifenslave
Documentation/networking/00-INDEX +0 -2
@@ -88,8 +88,6 @@ gianfar.txt - Gianfar Ethernet Driver. ieee802154.txt - Linux IEEE 802.15.4 implementation, API and drivers -ifenslave.c - - Configure network interfaces for parallel routing (bonding). igb.txt - README for the Intel Gigabit Ethernet Driver (igb). igbvf.txt
Documentation/networking/Makefile +0 -5
@@ -1,11 +1,6 @@ # kbuild trick to avoid linker error. Can be omitted if a module is built. obj- := dummy.o -# List of programs to build -hostprogs-y := ifenslave - -HOSTCFLAGS_ifenslave.o += -I$(objtree)/usr/include - # Tell kbuild to always build the programs always := $(hostprogs-y)
Documentation/networking/bonding.txt +10 -44
93 lines not on this page · raw message
Documentation/networking/ifenslave.c deleted +0 -1105
1,105 lines not on this page · raw message
Quoted 12 lines · Cong Wang
From: Cong Wang <[email protected]>
As Stephen proposed:
Since bonding supports configuration via iproute (netlink) and sysfs, I think it is time to purge the old ifenslave code out ofDocumentation/networkingand update the documentation.Suggested-by Stephen Hemminger <[email protected]>Cc Stephen Hemminger <[email protected]>Cc Jay Vosburgh <[email protected]>Cc "David S. Miller" <[email protected]>Signed-off-by Cong Wang <[email protected]>
...
Documentation/networking/bonding.txt reboots, edit the appropriate file (/etc/init.d/boot.local or · line 1153
Quoted 8 lines
Documentation/networking/bonding.txt +2
-2@@ -1183,8 +1149,8 @@ reboots, edit the appropriate file (/etc/init.d/boot.local or modprobe bonding mode=balance-alb miimon=100 modprobe e100 ifconfig bond0 192.168.1.1 netmask 255.255.255.0 up -ifenslave bond0 eth0 -ifenslave bond0 eth1 +ip link set eth0 master bond0 +ip link set eth1 master bond0
While cleaning up, we might replace the ifconfig here with ip as well.
Michal Kubecek
David Miller
maintainerFrom: Cong Wang <[email protected]>
Date: Tue, 28 May 2013 09:49:16 +0800
Quoted 7 lines
From: Cong Wang <[email protected]>
As Stephen proposed:
Since bonding supports configuration via iproute (netlink) and sysfs, I think it is time to purge the old ifenslave code out ofDocumentation/networkingand update the documentation.
Quoted 5 lines
Suggested-by Stephen Hemminger <[email protected]>Cc Stephen Hemminger <[email protected]>Cc Jay Vosburgh <[email protected]>Cc "David S. Miller" <[email protected]>Signed-off-by Cong Wang <[email protected]>
Yep, time to let this one go, applied, thanks!