ARM: socfpga: dts: Add support for SD/MMC

new file mode 100644
index 0000000..f218bb8
@@ -0,0 +1,60 @@
+* Altera SOCFPGA specific extensions to the Synopsis Designware Mobile
+  Storage Host Controller
+
+Required Properties:
+
+* compatible: should be
+	- "altr,socfpga-dw-mshc": for controllers with Altera SOCFPGA
+	  specific extensions.
+
+* altr,dw-mshc-ciu-div: Specifies the divider value for the card interface
+  unit (ciu) clock. The value should be (n-1). For Altera's SOCFPGA, the divider
+  value is fixed at 3, which mean parent_clock/4.
+
+* altr,dw-mshc-sdr-timing: Specifies the value of CIU clock phase shift value
+  in transmit mode and CIU clock phase shift value in receive mode for single
+  data rate mode operation. Refer notes below for the order of the cells and the
+  valid values.
+
+  Notes for the sdr-timing values:
+
+    The order of the cells should be
+      - First Cell: CIU clock phase shift value for RX mode, smplsel bits in
+	the system manager SDMMC control group.
+      - Second Cell: CIU clock phase shift value for TX mode, drvsel bits in
+	the system manager SDMMC control group.
+
+    Valid values for SDR CIU clock timing for SOCFPGA:
+      - valid value for tx phase shift and rx phase shift is 0 to 7.
+
+Required properties for a slot:
+
+* bus-width: Data width for card slot. 4-bit or 8-bit data.
+
+Example:
+
+  The MSHC controller node can be split into two portions, SoC specific and
+  board specific portions as listed below.
+
+	dwmmc0@ff704000 {
+		compatible = "altr,socfpga-dw-mshc";
+		reg = <0xff704000 0x1000>;
+		interrupts = <0 139 4>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+	};
+
+	dwmmc0@ff704000 {
+		num-slots = <1>;
+		supports-highspeed;
+		broken-cd;
+		fifo-depth = <0x400>;
+		altr,dw-mshc-ciu-div = <3>;
+      		altr,dw-mshc-sdr-timing = <0 3>;
+
+		slot@0 {
+			reg = <0>;
+			bus-width = <4>;
+		};
+	};
+

index bee62a2..dbf7f22 100644
@@ -468,6 +468,17 @@
 			cache-level = <2>;
 		};
 
+		mmc: dwmmc0@ff704000 {
+			compatible = "altr,socfpga-dw-mshc";
+			reg = <0xff704000 0x1000>;
+			interrupts = <0 139 4>;
+			fifo-depth = <0x400>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+			clocks = <&l4_mp_clk>, <&sdmmc_clk>;
+			clock-names = "biu", "ciu";
+		};
+
 		/* Local timer */
 		timer@fffec600 {
 			compatible = "arm,cortex-a9-twd-timer";

@@ -521,7 +532,7 @@
 			};
 
 		sysmgr@ffd08000 {
-				compatible = "altr,sys-mgr";
+				compatible = "altr,sys-mgr", "syscon";
 				reg = <0xffd08000 0x4000>;
 			};
 	};

index 973999d..1853cb1 100644
@@ -54,6 +54,19 @@
 			status = "okay";
 		};
 
+		dwmmc0@ff704000 {
+			num-slots = <1>;
+			supports-highspeed;
+			broken-cd;
+			altr,dw-mshc-ciu-div = <3>;
+			altr,dw-mshc-sdr-timing = <0 3>;
+
+			slot@0 {
+				reg = <0>;
+				bus-width = <4>;
+			};
+		};
+
 		timer0@ffc08000 {
 			clock-frequency = <100000000>;
 		};

index d1ec0ca..d93deb0 100644
@@ -46,6 +46,18 @@
 			status = "okay";
 		};
 
+		dwmmc0@ff704000 {
+			num-slots = <1>;
+			supports-highspeed;
+			broken-cd;
+			altr,dw-mshc-ciu-div = <3>;
+
+			slot@0 {
+				reg = <0>;
+				bus-width = <4>;
+			};
+		};
+
 		timer0@ffc08000 {
 			clock-frequency = <7000000>;
 		};

index 9ab8f8d..1be2289 100644
@@ -556,6 +556,14 @@ config MMC_DW_EXYNOS
 	  Synopsys DesignWare Memory Card Interface driver. Select this option
 	  for platforms based on Exynos4 and Exynos5 SoC's.
 
+config MMC_DW_SOCFPGA
+	tristate "SOCFPGA specific extensions for Synopsys DW Memory Card Interface"
+	depends on MMC_DW
+	select MMC_DW_PLTFM
+	help
+	  This selects support for Altera SoCFPGA specific extensions to the
+	  Synopsys DesignWare Memory Card Interface driver.
+
 config MMC_DW_PCI
 	tristate "Synopsys Designware MCI support on PCI bus"
 	depends on MMC_DW && PCI

index cd32280..67718c1 100644
@@ -42,6 +42,7 @@ obj-$(CONFIG_SDH_BFIN)		+= bfin_sdh.o
 obj-$(CONFIG_MMC_DW)		+= dw_mmc.o
 obj-$(CONFIG_MMC_DW_PLTFM)	+= dw_mmc-pltfm.o
 obj-$(CONFIG_MMC_DW_EXYNOS)	+= dw_mmc-exynos.o
+obj-$(CONFIG_MMC_DW_SOCFPGA)	+= dw_mmc-socfpga.o
 obj-$(CONFIG_MMC_DW_PCI)	+= dw_mmc-pci.o
 obj-$(CONFIG_MMC_SH_MMCIF)	+= sh_mmcif.o
 obj-$(CONFIG_MMC_JZ4740)	+= jz4740_mmc.o