Documentation: document all g_serial module parameters
Subsystems (2)
PATCH 1/1 Documentation: document all g_serial module parameters
Add a table explaining the module parameters that g_serial digests.
Signed-off-by Matt Porter <[email protected]>
--- Documentation/usb/gadget_serial.txt | 13 +++++++++++++ 1 file changed, 13 insertions(+)
Documentation/usb/gadget_serial.txt +13 -0
@@ -125,6 +125,19 @@ controller driver. This must be done each time you reboot the gadget side Linux system. You can add this to the start up scripts, if desired. +Additionally, there are several module parameters to change g_serial +behavior: + + Parameter Default Description + --------- ------- ----------- + use_acm 1 CDC ACM device + use_obex 0 CDC OBEX device + n_ports 1 Ports to instantiate + +To load g_serial as two ACM ports do this: + + modprobe g_serial n_ports=2 + Your system should use mdev (from busybox) or udev to make the device nodes. After this gadget driver has been set up you should then see a /dev/ttyGS0 node:
Signature · 1 line
1.7.9.5