Bluetooth: Disable upper layer connections when user channel is active
Subsystems (2)
Marcel Holtmann
maintainerPATCH 1/2 Bluetooth: Disable upper layer connections when user channel is active
When the device has the user channel flag set, it means it is driven by an user application. In that case do not allow any connections from L2CAP or SCO sockets.
This is the same situation as when the device has the raw flag set and it will then return EHOSTUNREACH.
--- net/bluetooth/hci_conn.c | 1 + 1 file changed, 1 insertion(+)
net/bluetooth/hci_conn.c +1 -0
@@ -518,6 +518,7 @@ struct hci_dev *hci_get_route(bdaddr_t *dst, bdaddr_t *src)list_for_each_entry (d, &hci_dev_list, list) {if (!test_bit (HCI_UP , &d->flags) ||test_bit (HCI_RAW , &d->flags) || +test_bit (HCI_USER_CHANNEL , &d->dev_flags) || d->dev_type !=HCI_BREDR )continue ;
Signature · 1 line
1.8.3.1
Hi Marcel,
Quoted 11 lines · Marcel Holtmann
When the device has the user channel flag set, it means it is driven by an user application. In that case do not allow any connections from L2CAP or SCO sockets.
This is the same situation as when the device has the raw flag set and it will then return EHOSTUNREACH.
Signed-off-by Marcel Holtmann <[email protected]>--- net/bluetooth/hci_conn.c | 1 + 1 file changed, 1 insertion(+)
Johan
Hi Marcel,
2013-09-03 Marcel Holtmann <[email protected]>:
Quoted 11 lines
When the device has the user channel flag set, it means it is driven by an user application. In that case do not allow any connections from L2CAP or SCO sockets.
This is the same situation as when the device has the raw flag set and it will then return EHOSTUNREACH.
Signed-off-by Marcel Holtmann <[email protected]>--- net/bluetooth/hci_conn.c | 1 + 1 file changed, 1 insertion(+)
Patch has been applied to bluetooth-next. Thanks.
Gustavo