ARM: dts: mxs: Add MSR M28CU3 board
Subsystems (5)
PATCH v2 1/1 ARM: dts: mxs: Add MSR M28CU3 board
This board is based on the M28 SoM with custom baseboard. Supported are LEDs, ethernet, PWM, LCD, SD slots.
Signed-off-by Marek Vasut <[email protected]>
Cc Shawn Guo <[email protected]>
--- arch/arm/boot/dts/Makefile | 1 + arch/arm/boot/dts/imx28-m28cu3.dts | 266 +++++++++++++++++++++++++++++++++++++ arch/arm/mach-mxs/mach-mxs.c | 7 + 3 files changed, 274 insertions(+) create mode 100644 arch/arm/boot/dts/imx28-m28cu3.dts
V2: Let the FEC driver handle the enet_out clock.
arch/arm/boot/dts/Makefile +1 -0
@@ -159,6 +159,7 @@ dtb-$(CONFIG_ARCH_MXS) += imx23-evk.dtb \ imx28-cfa10057.dtb \ imx28-cfa10058.dtb \ imx28-evk.dtb \ + imx28-m28cu3.dtb \ imx28-m28evk.dtb \ imx28-sps1.dtb \ imx28-tx28.dtb
arch/arm/boot/dts/imx28-m28cu3.dts new file +266 -0
266 lines not on this page · raw message
arch/arm/mach-mxs/mach-mxs.c +7 -0
@@ -332,6 +332,11 @@ static void __init crystalfontz_init(void)update_fec_mac_prop (OUI_CRYSTALFONTZ ); } +static void __init m28cu3_init (void ) +{ +update_fec_mac_prop (OUI_DENX ); +} +static const char __init *mxs_get_soc_id (void ) {struct device_node *np;
@@ -459,6 +464,8 @@ static void __init mxs_machine_init(void)apx4devkit_init (); else if (of_machine_is_compatible("crystalfontz,cfa10036")) crystalfontz_init(); + else if (of_machine_is_compatible("msr,m28cu3")) + m28cu3_init();of_platform_populate (NULL ,of_default_bus_match_table ,NULL ,parent );
Signature · 1 line
1.8.4.rc3
Shawn Guo
AppliedPATCH v2 1/1 ARM: dts: mxs: Add MSR M28CU3 board
Quoted 4 lines · Marek Vasut
This board is based on the M28 SoM with custom baseboard. Supported are LEDs, ethernet, PWM, LCD, SD slots.
Signed-off-by Marek Vasut <[email protected]>
Applied, thanks.