Bluetooth: Simplify device type check for AMP discover response
Subsystems (2)
Marcel Holtmann
maintainerPATCH 1/2 Bluetooth: Simplify device type check for AMP discover response
When counting the number for AMP controllers, a positive check is used. To be consistent, use the same check when actually adding the data for the AMP contollers.
Signed-off-by Marcel Holtmann <[email protected]>
--- net/bluetooth/a2mp.c | 18 +++++++----------- 1 file changed, 7 insertions(+), 11 deletions(-)
net/bluetooth/a2mp.c +7 -11
@@ -78,24 +78,20 @@ u8 __next_ident(struct amp_mgr *mgr)/* hci_dev_list shall be locked */ static void __a2mp_add_cl (struct amp_mgr *mgr,struct a2mp_cl *cl) { -int i =0 ;struct hci_dev *hdev; +int i =1 ; cl[0 ].id =AMP_ID_BREDR ; cl[0 ].type =AMP_TYPE_BREDR ; cl[0 ].status =AMP_STATUS_BLUETOOTH_ONLY ;list_for_each_entry (hdev, &hci_dev_list, list) { -/* Iterate through AMP controllers */ -if (hdev->dev_type !=HCI_AMP ) -continue ; - -/* Starting from second entry */ - ++i; - - cl[i].id = hdev->id; - cl[i].type = hdev->amp_type; - cl[i].status = hdev->amp_status; +if (hdev->dev_type ==HCI_AMP ) { + cl[i].id = hdev->id; + cl[i].type = hdev->amp_type; + cl[i].status = hdev->amp_status; + i++; + } } }
Signature · 1 line
1.8.3.1
Hi Marcel,
Quoted 8 lines · Marcel Holtmann
When counting the number for AMP controllers, a positive check is used. To be consistent, use the same check when actually adding the data for the AMP contollers.
Signed-off-by Marcel Holtmann <[email protected]>--- net/bluetooth/a2mp.c | 18 +++++++----------- 1 file changed, 7 insertions(+), 11 deletions(-)
Both patches in this set have been applied to bluetooth-next. Thanks.
Johan