Bluetooth: Read flow control mode on AMP controller init
Subsystems (2)
Marcel Holtmann
maintainerPATCH 2/2 Bluetooth: Read flow control mode on AMP controller init
When initializing an AMP controller, read its current flow control mode so that the correct value is used.
The AMP controller defaults to block based flow control and this extra command is just to double check.
Signed-off-by Marcel Holtmann <[email protected]>
--- net/bluetooth/hci_core.c | 3 +++ 1 file changed, 3 insertions(+)
net/bluetooth/hci_core.c +3 -0
@@ -319,6 +319,9 @@ static void amp_init(struct hci_request *req)/* Read Data Blk size */ hci_req_add (req,HCI_OP_READ_DATA_BLOCK_SIZE ,0 ,NULL ); +/* Read Flow Control Mode */ +hci_req_add (req,HCI_OP_READ_FLOW_CONTROL_MODE ,0 ,NULL ); +/* Read Location Data */ hci_req_add (req,HCI_OP_READ_LOCATION_DATA ,0 ,NULL ); }
Signature · 1 line
1.8.3.1