Bluetooth: Add support for setting DUT mode
Subsystems (2)
Marcel Holtmann
maintainerPATCH v2 2/3 Bluetooth: Add support for setting DUT mode
The Device Under Test (DUT) mode is useful for doing certification testing and so expose this as debugfs option.
This mode is actually special since you can only enter it. Restoring normal operation means that a HCI Reset is required. The current mode value gets tracked as a new device flag and when disabling it, the correct command to reset the controller is sent.
Signed-off-by Marcel Holtmann <[email protected]>
--- include/net/bluetooth/hci.h | 3 ++ net/bluetooth/hci_core.c | 73 +++++++++++++++++++++++++++++++++++++++++++++ 2 files changed, 76 insertions(+)
include/net/bluetooth/hci.h +3 -0
@@ -115,6 +115,7 @@ enum {HCI_PAIRABLE ,HCI_SERVICE_CACHE ,HCI_DEBUG_KEYS , +HCI_DUT_MODE ,HCI_UNREGISTER , HCI_USER_CHANNEL,
@@ -1043,6 +1044,8 @@ struct hci_rp_write_remote_amp_assoc {__u8 phy_handle; } __packed; +#define HCI_OP_ENABLE_DUT_MODE 0x1803 +#define HCI_OP_WRITE_SSP_DEBUG_MODE 0x1804#define HCI_OP_LE_SET_EVENT_MASK 0x2001
net/bluetooth/hci_core.c +73 -0
85 lines not on this page · raw message
Signature · 1 line
1.8.3.1