How to determinate max_req_size and max_blk_count settings
Hi,
I'm working on a sd/mmc driver.
The controller has a BLKLEN setting, however here is no register to set block_count setting.
The datasheet says for Multi-Block Read/Write:
host needs to stop controller manually by setting STPCMD to 1 when all data is received/transmitted. Host also needs to start CMD12 on the bus to stop the card. The datasheet does not mention the limitation on block_count.
So my question is how to determinate max_req_size and max_blk_count settings in driver since the controller only has a BLKLEN setting in register.
Yet another question is:
I got some messages while copying file to sd card:
[ 35.602813] mmcblk0: error -5 transferring data, sector 11008, nr 64, cmd response 0x900, card status 0xc00 [ 35.639143] end_request: I/O error, dev mmcblk0, sector 11008 [ 35.645170] end_request: I/O error, dev mmcblk0, sector 11016 [ 35.651690] end_request: I/O error, dev mmcblk0, sector 11024 [ 35.658095] end_request: I/O error, dev mmcblk0, sector 11032 [ 35.664090] end_request: I/O error, dev mmcblk0, sector 11040 [ 35.670570] end_request: I/O error, dev mmcblk0, sector 11048 [ 35.676541] end_request: I/O error, dev mmcblk0, sector 11056 [ 35.682997] end_request: I/O error, dev mmcblk0, sector 11064
The copy looks success.
(Destination file size looks ok.
And if I copy an executable file, I can execute it. So I think the copy is success.)
But I'm still have no idea how to debug such I/O error now. Any comments/hits to debug such issue?
Thanks,
Axel