vt8500: pinctrl: Change devicetree data parsing
PATCH RESEND v2 1/1 vt8500: pinctrl: Change devicetree data parsing
Due to an assumption in the VT8500 pinctrl driver, the value passed from devicetree for 'wm,pull' was not explicitly translated before being passed to pinconf.
Since v3.10, changes to 'enum pin_config_param', PIN_CONFIG_BIAS_PULL_(UP/DOWN) no longer map 1-to-1 with the expected values in devicetree.
This patch adds a small translation between the devicetree values (0..2) and the enum pin_config_param equivalent values.
---
v2:
Minor change in commit message to indicate time since problem occurred. Change assigned variable to configs[0] rather than reassigning to pull. Add a default case to the switch to prevent static checker errors.
v2 resend:
Correct Linus' email address
drivers/pinctrl/vt8500/pinctrl-wmt.c | 15 ++++++++++++++- 1 file changed, 14 insertions(+), 1 deletion(-)
drivers/pinctrl/vt8500/pinctrl-wmt.c +14 -1
@@ -276,7 +276,20 @@ static int wmt_pctl_dt_node_to_map_pull(struct wmt_pinctrl_data *data,if (!configs)return -ENOMEM ; - configs[0 ] = pull; +switch (pull) { +case 0 : + configs[0 ] =PIN_CONFIG_BIAS_DISABLE ; +break ; +case 1 : + configs[0 ] =PIN_CONFIG_BIAS_PULL_DOWN ; +break ; +case 2 : + configs[0 ] =PIN_CONFIG_BIAS_PULL_UP ; +break ; +default : + configs[0 ] =PIN_CONFIG_BIAS_DISABLE ; +dev_err (data->dev,"invalid pull state %d - disabling\n" , pull); + } map->type =PIN_MAP_TYPE_CONFIGS_PIN ; map->data.configs.group_or_pin = data->groups[group];
Signature · 1 line
1.7.9.5
Quoted 7 lines · Tony Prisk
Due to an assumption in the VT8500 pinctrl driver, the value passed from devicetree for 'wm,pull' was not explicitly translated before being passed to pinconf.
Since v3.10, changes to 'enum
pin_config_param',PIN_CONFIG_BIAS_PULL_(UP/DOWN)no longer map 1-to-1 with the expected values in devicetree.
Quoted 6 lines
This patch adds a small translation between the devicetree values (0..2) and the enum
pin_config_paramequivalent values.Signed-off-by Tony Prisk <[email protected]>---
v2:
Patch applied to fixes and tagged for stable v3.10+
Yours,
Linus Walleij