bnx2x: Add missing bit in default Tx switching
PATCH 1/1 bnx2x: Add missing bit in default Tx switching
Commit c14db2025 "bnx2x: Correct default Tx switching behaviour" supposedly changed the default Tx switching behaviour, but was missing the fastpath change required for FW to pass packets from PFs to VFs.
Signed-off-by Yuval Mintz <[email protected]>
Signed-off-by Ariel Elior <[email protected]>
---
Hi Dave,
Please consider applying this to `net'.
Thanks,
Yuval
--- drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-)
drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c +8 -1
@@ -3875,7 +3875,9 @@ netdev_tx_t bnx2x_start_xmit(struct sk_buff *skb, struct net_device *dev) xmit_type); } -/* Add the macs to the parsing BD this is a vf */ +/* Add the macs to the parsing BD if this is a vf or if +* Tx Switching is enabled. +*/ if (IS_VF (bp)) {/* override GRE parameters in BD */ bnx2x_set_fw_mac_addr(&pbd_e2->data.mac_addr.src_hi,
@@ -3887,6 +3889,11 @@ netdev_tx_t bnx2x_start_xmit(struct sk_buff *skb, struct net_device *dev) &pbd_e2->data.mac_addr.dst_mid, &pbd_e2->data.mac_addr.dst_lo, eth->h_dest); + }else if (bp->flags &TX_SWITCHING ) { +bnx2x_set_fw_mac_addr (&pbd_e2->data.mac_addr.dst_hi, + &pbd_e2->data.mac_addr.dst_mid, + &pbd_e2->data.mac_addr.dst_lo, + eth->h_dest); } SET_FLAG(pbd_e2_parsing_data,
Signature · 1 line
1.8.1.227.g44fe835
From: Yuval Mintz <[email protected]>
Date: Thu, 27 Feb 2014 15:42:26 +0200
Quoted 6 lines
Commit
c14db2025"bnx2x: Correct default Tx switching behaviour" supposedly changed the default Tx switching behaviour, but was missing the fastpath change required for FW to pass packets from PFs to VFs.Signed-off-by Yuval Mintz <[email protected]>Signed-off-by Ariel Elior <[email protected]>
Applied, thank you.