m32r: remove check for CONFIG_IDC_AK4524

PATCH New Paul Bolle 1 participant 1 message May 20, 2014

Share & tools

Paul Bolle

author

2014-05-20 08:03 UTC #0 lore raw

PATCH 1/1 m32r: remove check for CONFIG_IDC_AK4524

There's been a check for CONFIG_IDC_AK4524 and its MODULE variant in m32r's code ever since it was added in v2.6.9. But there has never been a Kconfig symbol IDC_AK4524. Remove this check.

Signed-off-by Paul Bolle <[email protected]>

---
Untested.

 arch/m32r/platforms/usrv/setup.c | 9 ---------
 1 file changed, 9 deletions(-)

arch/m32r/platforms/usrv/setup.c +0 -9

index dcde0ec777f6..04af9c2a83d9 100644
@@ -194,15 +194,6 @@ void __init init_IRQ(void)
 	disable_m32700ut_pld_irq(PLD_IRQ_UART1);
 #endif	/* CONFIG_SERIAL_8250 || CONFIG_SERIAL_8250_MODULE */
 
-#if defined(CONFIG_IDC_AK4524) || defined(CONFIG_IDC_AK4524_MODULE)
-	/* INT#80: AK4524 IREQ on PLD */
-	irq_set_chip_and_handler(PLD_IRQ_SNDINT, &m32700ut_pld_irq_type,
-				 handle_level_irq);
-	pld_icu_data[irq2pldirq(PLD_IRQ_SNDINT)].icucr
-		= PLD_ICUCR_ISMOD01;	/* 'L' level sense */
-	disable_m32700ut_pld_irq(PLD_IRQ_SNDINT);
-#endif	/* CONFIG_IDC_AK4524 || CONFIG_IDC_AK4524_MODULE */
-
 	/*
 	 * INT1# is used for UART, MMC, CF Controller in FPGA.
 	 * We enable it here.

Signature · 1 line

1.9.0