sbc8548: enable and test CONFIG_SYS_GENERIC_BOARD

Tested on the following baseline (note "dirty" since I enabled ALT_BOOT in the config in order to use the alternate boot bank.)

Everything seems to work fine with no additional changes. The banner warning message is now gone.

---

U-Boot 2014.10-rc1-00075-ge49f14af1349-dirty (Aug 14 2014 - 10:26:15)

CPU:   8548E, Version: 2.1, (0x80390021)
Core:  e500, Version: 2.2, (0x80210022)
Clock Configuration:
       CPU0:990  MHz,
       CCB:396  MHz,
       DDR:198  MHz (396 MT/s data rate), LBC:99   MHz
L1:    D-cache 32 KiB enabled
       I-cache 32 KiB enabled
I2C:   ready
DRAM:  Detected UDIMM
    SDRAM: 128 MiB
256 MiB (DDR2, 64-bit, CL=3, ECC off)
Flash: 72 MiB
L2:    512 KiB enabled

*** Warning - bad CRC, using default environment

PCI: Host, 64 bit, 66 MHz, sync, arbiter
00:01.0 - 8086:1026 - Network controller
PCI1: Bus 00 - 00

PCIe1: Root Complex, x1 gen1, regs @ 0xe000a000
02:00.0 - 1148:9e00 - Network controller

PCIe1: Bus 01 - 02
In:    serial
Out:   serial
Err:   serial
Net:   eTSEC0 [PRIME], eTSEC1
Hit any key to stop autoboot:  0

=> ver

U-Boot 2014.10-rc1-00075-ge49f14af1349-dirty (Aug 14 2014 - 10:26:15) powerpc-linux-gcc (GCC) 4.5.2
GNU ld (GNU Binutils) 2.21
=>

---

---
 include/configs/sbc8548.h | 2 ++
 1 file changed, 2 insertions(+)

index f28f350fcc86..aee0d9e27309 100644
@@ -13,6 +13,8 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
+#define CONFIG_SYS_GENERIC_BOARD
+
 /*
  * Top level Makefile configuration choices
  */

1.9.2

Applied to u-boot-mpc85xx master. Thanks.

York