Skip to contentSkip to conversation

cmd_mmc: fix bootpart-resize maxarg to 4

PATCH New Wally Yeh 2 participants 2 messages Sep 25, 2014

lore
Share & tools
lore

Wally Yeh

author
#0 lore raw

PATCH 1/1 cmd_mmc: fix bootpart-resize maxarg to 4

sub-command 'bootpart-resize' check for argc == 4, it will retrun CMD_RET_FAILURE when argc value not matched.

but bootpart-resize's maxarg is 3, which means you never execute this sub-command successfully.

fix it by change bootpart-resize maxarg to 4.

Cc Wolfgang Denk <[email protected]>
Cc Pierre Aubert <[email protected]>
---
 common/cmd_mmc.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
common/cmd_mmc.c +1 -1
index 1e40983..4286e26 100644
@@ -602,7 +602,7 @@ static cmd_tbl_t cmd_mmc[] = {
  U_BOOT_CMD_MKENT(list, 1, 1, do_mmc_list, "", ""),
 #ifdef CONFIG_SUPPORT_EMMC_BOOT
  U_BOOT_CMD_MKENT(bootbus, 5, 0, do_mmc_bootbus, "", ""),
- U_BOOT_CMD_MKENT(bootpart-resize, 3, 0, do_mmc_boot_resize, "", ""),
+ U_BOOT_CMD_MKENT(bootpart-resize, 4, 0, do_mmc_boot_resize, "", ""),
  U_BOOT_CMD_MKENT(partconf, 5, 0, do_mmc_partconf, "", ""),
  U_BOOT_CMD_MKENT(rst-function, 3, 0, do_mmc_rst_func, "", ""),
 #endif
Signature · 1 line
1.7.10.4
#1 lore raw

PATCH 1/1 cmd_mmc: fix bootpart-resize maxarg to 4

sorry for send this patch two times, It shows being held until the list moderator can review it for approval.

I think maybe I didn't register the correct mail address and sent it again. but it still show wait for moderator review.

At last I register my private mail address to this list and found I have post the same post two time.

I'm so sorry for this mistake.

Wally