m68k/atari - smc91x: remove Atari special case handling for SMC_PUSH_DATA

index 3a8069f..14c5325 100644
@@ -223,8 +223,6 @@ SMC_outw(u16 val, void __iomem *ioaddr, int reg)
 #define SMC_CAN_USE_32BIT       1
 #define SMC_NOWAIT              1
 
-#define writew_be(val, addr) out_be16((addr), (val))
-
 #define SMC_inb(a, r)           readb((a) + (r))
 #define SMC_inw(a, r)           readw((a) + (r))
 #define SMC_inl(a, r)           readl((a) + (r))

@@ -1128,40 +1126,6 @@ static const char * chip_ids[ 16 ] =  {
 		}							\
 	} while (0)
 
-#if defined(CONFIG_ATARI)
-/*
- * MSch: EtherNAT is 32 bit, so the misaligned data buffer hack applies.
- * This appears to hurt quite a lot ... we actually need to byte swap the
- * misaligned write because the data end up in the packet buffer swapped
- * otherwise (resulting in the first two bytes of the target MAC address
- * being swapped)
- */
-#define SMC_PUSH_DATA(lp, p, l)					\
-	do {								\
-		if (SMC_32BIT(lp)) {				\
-			void *__ptr = (p);				\
-			int __len = (l);				\
-			void __iomem *__ioaddr = ioaddr;		\
-			if (__len >= 2 && (unsigned long)__ptr & 2) {	\
-				__len -= 2;				\
-				SMC_outw_be(*(u16 *)__ptr, ioaddr,	\
-					DATA_REG(lp));		\
-				__ptr += 2;				\
-			}						\
-			if (SMC_CAN_USE_DATACS && lp->datacs)		\
-				__ioaddr = lp->datacs;			\
-			SMC_outsl(__ioaddr, DATA_REG(lp), __ptr, __len>>2); \
-			if (__len & 2) {				\
-				__ptr += (__len & ~3);			\
-				SMC_outw_be(*((u16 *)__ptr), ioaddr,	\
-					 DATA_REG(lp));		\
-			}						\
-		} else if (SMC_16BIT(lp))				\
-			SMC_outsw(ioaddr, DATA_REG(lp), (u16 *) p, (l) >> 1); \
-		else if (SMC_8BIT(lp))				\
-			SMC_outsb(ioaddr, DATA_REG(lp), p, l);	\
-	} while (0)
-#else
 #define SMC_PUSH_DATA(lp, p, l)					\
 	do {								\
 		if (SMC_32BIT(lp)) {				\

@@ -1185,7 +1149,6 @@ static const char * chip_ids[ 16 ] =  {
 		else if (SMC_8BIT(lp))				\
 			SMC_outsb(ioaddr, DATA_REG(lp), p, l);	\
 	} while (0)
-#endif
 
 #define SMC_PULL_DATA(lp, p, l)					\
 	do {								\