staging: rtl8188eu: use %pM specifier instead of passing direct values
PATCH v3 1/1 staging: rtl8188eu: use %pM specifier instead of passing direct values
The patch converts code to use %pM specifier instead of pushing each byte via stack.
Signed-off-by Mike Krinkin <[email protected]>
---
Changes v2 -> v3:
- actual use of %pM instead %*ph as suggested by Larry Finger.
drivers/staging/rtl8188eu/hal/usb_halinit.c | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-)
drivers/staging/rtl8188eu/hal/usb_halinit.c +2 -4
@@ -1096,10 +1096,8 @@ static void Hal_EfuseParseMACAddr_8188EU(struct adapter *adapt, u8 *hwinfo, boolmemcpy (eeprom->mac_addr, &hwinfo[EEPROM_MAC_ADDR_88EU ],ETH_ALEN ); }RT_TRACE (_module_hci_hal_init_c_, _drv_notice_, - ("Hal_EfuseParseMACAddr_8188EU: Permanent Address = %02x-%02x-%02x-%02x-%02x-%02x\n" , - eeprom->mac_addr[0 ], eeprom->mac_addr[1 ], - eeprom->mac_addr[2 ], eeprom->mac_addr[3 ], - eeprom->mac_addr[4 ], eeprom->mac_addr[5 ])); + ("Hal_EfuseParseMACAddr_8188EU: Permanent Address = %pM\n" , + eeprom->mac_addr)); } static void
Signature · 1 line
1.9.1