gpio: bcm-kona: Implement get_direction callback

PATCH In review Axel Lin 3 participants 3 messages Apr 13, 2015 – Apr 27, 2015

Subsystems (3)

GPIO Broadcom BCM281XX/BCM11XXX/BCM216XX Arm architecture Broadcom kona GPIO driver

lore

Share & tools

lore

Axel Lin

author

2015-04-13 07:56 UTC #0 lore raw

PATCH v2 1/1 gpio: bcm-kona: Implement get_direction callback

Implement gpio_chip's get_direction() callback, that lets other drivers get particular GPIOs direction using gpiod_get_direction().

Signed-off-by Axel Lin <[email protected]>

---
v2: Make bcm_kona_gpio_get_dir explicitly return GPIOF_DIR_IN or GPIOF_DIR_OUT.

 drivers/gpio/gpio-bcm-kona.c | 26 ++++++++++++++++----------
 1 file changed, 16 insertions(+), 10 deletions(-)

drivers/gpio/gpio-bcm-kona.c +16 ~~-10~~

index b164ce8..a6e7922 100644
@@ -122,6 +122,16 @@ static void bcm_kona_gpio_unlock_gpio(struct bcm_kona_gpio *kona_gpio,
 	spin_unlock_irqrestore(&kona_gpio->lock, flags);
 }
 
+static int bcm_kona_gpio_get_dir(struct gpio_chip *chip, unsigned gpio)
+{
+	struct bcm_kona_gpio *kona_gpio = to_kona_gpio(chip);
+	void __iomem *reg_base = kona_gpio->reg_base;
+	u32 val;
+
+	val = readl(reg_base + GPIO_CONTROL(gpio)) & GPIO_GPCTR0_IOTR_MASK;
+	return val ? GPIOF_DIR_IN : GPIOF_DIR_OUT;
+}
+
 static void bcm_kona_gpio_set(struct gpio_chip *chip, unsigned gpio, int value)
 {
 	struct bcm_kona_gpio *kona_gpio;

@@ -135,12 +145,8 @@ static void bcm_kona_gpio_set(struct gpio_chip *chip, unsigned gpio, int value)
 	reg_base = kona_gpio->reg_base;
 	spin_lock_irqsave(&kona_gpio->lock, flags);
 
-	/* determine the GPIO pin direction */
-	val = readl(reg_base + GPIO_CONTROL(gpio));
-	val &= GPIO_GPCTR0_IOTR_MASK;
-
 	/* this function only applies to output pin */
-	if (GPIO_GPCTR0_IOTR_CMD_INPUT == val)
+	if (bcm_kona_gpio_get_dir(chip, gpio) == GPIOF_DIR_IN)
 		goto out;
 
 	reg_offset = value ? GPIO_OUT_SET(bank_id) : GPIO_OUT_CLEAR(bank_id);

@@ -166,13 +172,12 @@ static int bcm_kona_gpio_get(struct gpio_chip *chip, unsigned gpio)
 	reg_base = kona_gpio->reg_base;
 	spin_lock_irqsave(&kona_gpio->lock, flags);
 
-	/* determine the GPIO pin direction */
-	val = readl(reg_base + GPIO_CONTROL(gpio));
-	val &= GPIO_GPCTR0_IOTR_MASK;
+	if (bcm_kona_gpio_get_dir(chip, gpio) == GPIOF_DIR_IN)
+		reg_offset = GPIO_IN_STATUS(bank_id);
+	else
+		reg_offset = GPIO_OUT_STATUS(bank_id);
 
 	/* read the GPIO bank status */
-	reg_offset = (GPIO_GPCTR0_IOTR_CMD_INPUT == val) ?
-	    GPIO_IN_STATUS(bank_id) : GPIO_OUT_STATUS(bank_id);
 	val = readl(reg_base + reg_offset);
 
 	spin_unlock_irqrestore(&kona_gpio->lock, flags);

@@ -310,6 +315,7 @@ static struct gpio_chip template_chip = {
 	.owner = THIS_MODULE,
 	.request = bcm_kona_gpio_request,
 	.free = bcm_kona_gpio_free,
+	.get_direction = bcm_kona_gpio_get_dir,
 	.direction_input = bcm_kona_gpio_direction_input,
 	.get = bcm_kona_gpio_get,
 	.direction_output = bcm_kona_gpio_direction_output,

Signature · 1 line

1.9.1

Ray Jui

maintainer Reviewed-by on v2 1/1

2015-04-13 19:09 UTC #1 lore raw

Quoted 65 lines · Axel Lin

Implement gpio_chip's get_direction() callback, that lets other drivers get particular GPIOs direction using gpiod_get_direction().

Signed-off-by Axel Lin <[email protected]>

---
v2: Make bcm_kona_gpio_get_dir explicitly return GPIOF_DIR_IN or GPIOF_DIR_OUT.

 drivers/gpio/gpio-bcm-kona.c | 26 ++++++++++++++++----------
 1 file changed, 16 insertions(+), 10 deletions(-)

drivers/gpio/gpio-bcm-kona.c +15 ~~-10~~

index b164ce8..a6e7922 100644
@@ -122,6 +122,16 @@ static void bcm_kona_gpio_unlock_gpio(struct bcm_kona_gpio *kona_gpio,
 	spin_unlock_irqrestore(&kona_gpio->lock, flags);
 }
 
+static int bcm_kona_gpio_get_dir(struct gpio_chip *chip, unsigned gpio)
+{
+	struct bcm_kona_gpio *kona_gpio = to_kona_gpio(chip);
+	void __iomem *reg_base = kona_gpio->reg_base;
+	u32 val;
+
+	val = readl(reg_base + GPIO_CONTROL(gpio)) & GPIO_GPCTR0_IOTR_MASK;
+	return val ? GPIOF_DIR_IN : GPIOF_DIR_OUT;
+}
+
 static void bcm_kona_gpio_set(struct gpio_chip *chip, unsigned gpio, int value)
 {
 	struct bcm_kona_gpio *kona_gpio;

@@ -135,12 +145,8 @@ static void bcm_kona_gpio_set(struct gpio_chip *chip, unsigned gpio, int value)
 	reg_base = kona_gpio->reg_base;
 	spin_lock_irqsave(&kona_gpio->lock, flags);
 
-	/* determine the GPIO pin direction */
-	val = readl(reg_base + GPIO_CONTROL(gpio));
-	val &= GPIO_GPCTR0_IOTR_MASK;
-
 	/* this function only applies to output pin */
-	if (GPIO_GPCTR0_IOTR_CMD_INPUT == val)
+	if (bcm_kona_gpio_get_dir(chip, gpio) == GPIOF_DIR_IN)
 		goto out;
 
 	reg_offset = value ? GPIO_OUT_SET(bank_id) : GPIO_OUT_CLEAR(bank_id);

@@ -166,13 +172,12 @@ static int bcm_kona_gpio_get(struct gpio_chip *chip, unsigned gpio)
 	reg_base = kona_gpio->reg_base;
 	spin_lock_irqsave(&kona_gpio->lock, flags);
 
-	/* determine the GPIO pin direction */
-	val = readl(reg_base + GPIO_CONTROL(gpio));
-	val &= GPIO_GPCTR0_IOTR_MASK;
+	if (bcm_kona_gpio_get_dir(chip, gpio) == GPIOF_DIR_IN)
+		reg_offset = GPIO_IN_STATUS(bank_id);
+	else
+		reg_offset = GPIO_OUT_STATUS(bank_id);
 
 	/* read the GPIO bank status */
-	reg_offset = (GPIO_GPCTR0_IOTR_CMD_INPUT == val) ?
-	    GPIO_IN_STATUS(bank_id) : GPIO_OUT_STATUS(bank_id);
 	val = readl(reg_base + reg_offset);
 
 	spin_unlock_irqrestore(&kona_gpio->lock, flags);

drivers/gpio/gpio-bcm-kona.c static struct gpio_chip template_chip = { · line 321

Quoted 7 lines

drivers/gpio/gpio-bcm-kona.c +1 -0

@@ -310,6 +315,7 @@ static struct gpio_chip template_chip = {
 	.owner = THIS_MODULE,
 	.request = bcm_kona_gpio_request,
 	.free = bcm_kona_gpio_free,
+	.get_direction = bcm_kona_gpio_get_dir,
 	.direction_input = bcm_kona_gpio_direction_input,
 	.get = bcm_kona_gpio_get,
 	.direction_output = bcm_kona_gpio_direction_output,

This change looks good to me!

Reviewed-by Ray Jui <[email protected]>

Thanks!

Ray

Linus Walleij

2015-04-27 13:30 UTC #2 lore raw

In reply to Axel Lin

Quoted 6 lines · Axel Lin

Implement gpio_chip's get_direction() callback, that lets other drivers get particular GPIOs direction using gpiod_get_direction().
Signed-off-by Axel Lin <[email protected]>
---
v2: Make bcm_kona_gpio_get_dir explicitly return GPIOF_DIR_IN or GPIOF_DIR_OUT.

Patch applied with Ray's review tag.

Yours,
Linus Walleij