ipv6: sysctl to restrict candidate source addresses
Subsystems (4)
PATCH v5 1/1 ipv6: sysctl to restrict candidate source addresses
Per RFC 6724, section 4, "Candidate Source Addresses":
It is RECOMMENDED that the candidate source addresses be the set of unicast addresses assigned to the interface that will be used to send to the destination (the "outgoing" interface).
Add a sysctl to enable this behaviour.
Signed-off-by Erik Kline <[email protected]>
--- Documentation/networking/ip-sysctl.txt | 7 +++++++ include/linux/ipv6.h | 1 + include/uapi/linux/ipv6.h | 1 + net/ipv6/addrconf.c | 22 +++++++++++++++++++--- 4 files changed, 28 insertions(+), 3 deletions(-)
Documentation/networking/ip-sysctl.txt +7 -0
@@ -1460,6 +1460,13 @@ router_solicitations - INTEGER routers are present. Default: 3 +use_oif_addrs_only - BOOLEAN + When enabled, the candidate source addresses for destinations + routed via this interface are restricted to the set of addresses + configured on this interface (vis. RFC 6724, section 4). + + Default: false + use_tempaddr - INTEGER Preference for Privacy Extensions (RFC3041). <= 0 : disable Privacy Extensions
include/linux/ipv6.h +1 -0
@@ -57,6 +57,7 @@ struct ipv6_devconf {bool initialized;struct in6_addr secret; } stable_secret; +__s32 use_oif_addrs_only;void *sysctl; };
include/uapi/linux/ipv6.h +1 -0
@@ -171,6 +171,7 @@ enum {DEVCONF_USE_OPTIMISTIC ,DEVCONF_ACCEPT_RA_MTU ,DEVCONF_STABLE_SECRET , +DEVCONF_USE_OIF_ADDRS_ONLY , DEVCONF_MAX };
net/ipv6/addrconf.c +19 -3
@@ -211,7 +211,8 @@ static struct ipv6_devconf ipv6_devconf __read_mostly = { .accept_ra_mtu = 1, .stable_secret = { .initialized = false, - } + }, + .use_oif_addrs_only = 0, };static struct ipv6_devconf ipv6_devconf_dflt__read_mostly = {
@@ -253,6 +254,7 @@ static struct ipv6_devconf ipv6_devconf_dflt __read_mostly = { .stable_secret = { .initialized = false, }, + .use_oif_addrs_only = 0, };/* Check if a valid qdisc is available */
@@ -1472,11 +1474,16 @@ int ipv6_dev_get_saddr(struct net *net, const struct net_device *dst_dev,* include addresses assigned to interfaces * belonging to the same site as the outgoing * interface.) +* - "It is RECOMMENDED that the candidate source addresses +* be the set of unicast addresses assigned to the +* interface that will be used to send to the destination +* (the 'outgoing' interface)." (RFC 6724) */ if (dst_dev) { + idev =__in6_dev_get (dst_dev);if ((dst_type &IPV6_ADDR_MULTICAST ) || - dst.scope <=IPV6_ADDR_SCOPE_LINKLOCAL ) { - idev =__in6_dev_get (dst_dev); + dst.scope <=IPV6_ADDR_SCOPE_LINKLOCAL || + (idev && idev->cnf.use_oif_addrs_only)) { use_oif_addr = true; } }
@@ -4607,6 +4614,7 @@ static inline void ipv6_store_devconf(struct ipv6_devconf *cnf, array[DEVCONF_ACCEPT_RA_FROM_LOCAL ] = cnf->accept_ra_from_local; array[DEVCONF_ACCEPT_RA_MTU ] = cnf->accept_ra_mtu;/* we omit DEVCONF_STABLE_SECRET for now */ + array[DEVCONF_USE_OIF_ADDRS_ONLY ] = cnf->use_oif_addrs_only; }static inline size_t inet6_ifla6_size (void )
@@ -5606,6 +5614,14 @@ static struct addrconf_sysctl_table .proc_handler = addrconf_sysctl_stable_secret, }, { + .procname = "use_oif_addrs_only", + .data = &ipv6_devconf.use_oif_addrs_only, + .maxlen = sizeof(int), + .mode = 0644, + .proc_handler = proc_dointvec, + + }, + {/* sentinel */ } },
Signature · 1 line
2.4.3.573.g4eafbef
From: Erik Kline <[email protected]>
Date: Wed, 22 Jul 2015 16:38:25 +0900
Quoted 9 lines
Per RFC 6724, section 4, "Candidate Source Addresses":
It is RECOMMENDED that the candidate source addresses be the set of unicast addresses assigned to the interface that will be used to send to the destination (the "outgoing" interface).
Add a sysctl to enable this behaviour.
Signed-off-by Erik Kline <[email protected]>
Applied, thanks.