ARM: tegra: Use consistent indentation for SATA node
Subsystems (2)
PATCH 1/1 ARM: tegra: Use consistent indentation for SATA node
From: Thierry Reding <[email protected]>
The indentation for properties in the SATA device tree node on Tegra124 deviates from the rest of the device tree file. Restore consistency and get rid of a couple of gratuitous blank lines while at it.
Signed-off-by Thierry Reding <[email protected]>
--- arch/arm/boot/dts/tegra124.dtsi | 19 ++++++------------- 1 file changed, 6 insertions(+), 13 deletions(-)
arch/arm/boot/dts/tegra124.dtsi +6 -13
@@ -624,28 +624,21 @@ sata@0,70020000 { compatible = "nvidia,tegra124-ahci"; - reg = <0x0 0x70027000 0x0 0x2000>, /* AHCI */ - <0x0 0x70020000 0x0 0x7000>; /* SATA */ - + <0x0 0x70020000 0x0 0x7000>; /* SATA */ interrupts = <GIC_SPI 23 IRQ_TYPE_LEVEL_HIGH>; - clocks = <&tegra_car TEGRA124_CLK_SATA>, - <&tegra_car TEGRA124_CLK_SATA_OOB>, - <&tegra_car TEGRA124_CLK_CML1>, - <&tegra_car TEGRA124_CLK_PLL_E>; + <&tegra_car TEGRA124_CLK_SATA_OOB>, + <&tegra_car TEGRA124_CLK_CML1>, + <&tegra_car TEGRA124_CLK_PLL_E>; clock-names = "sata", "sata-oob", "cml1", "pll_e"; - resets = <&tegra_car 124>, - <&tegra_car 123>, - <&tegra_car 129>; + <&tegra_car 123>, + <&tegra_car 129>; reset-names = "sata", "sata-oob", "sata-cold"; - power-domains = <&pmc TEGRA_POWERGATE_SATA>; - phys = <&padctl TEGRA_XUSB_PADCTL_SATA>; phy-names = "sata-phy"; - status = "disabled"; };
Signature · 1 line
2.5.0