arm: at91: reworked meesc board support

index c5994e0..b7f9f90 100644
@@ -3,7 +3,7 @@
  * Stelian Pop <[email protected]>
  * Lead Tech Design <www.leadtechdesign.com>
  *
- * (C) Copyright 2009-2011
+ * (C) Copyright 2009-2015
  * Daniel Gorsulowski <[email protected]>
  * esd electronic system design gmbh <www.esd.eu>
  *

@@ -28,6 +28,7 @@ DECLARE_GLOBAL_DATA_PTR;
  * Miscelaneous platform dependent initialisations
  */
 
+#ifdef CONFIG_REVISION_TAG
 static int hw_rev = -1;	/* hardware revision */
 
 int get_hw_rev(void)

@@ -45,6 +46,7 @@ int get_hw_rev(void)
 
 	return hw_rev;
 }
+#endif /* CONFIG_REVISION_TAG */
 
 #ifdef CONFIG_CMD_NAND
 static void meesc_nand_hw_init(void)

@@ -125,12 +127,18 @@ static void meesc_ethercat_hw_init(void)
 
 int dram_init(void)
 {
-	gd->ram_size = get_ram_size(
-		(void *)CONFIG_SYS_SDRAM_BASE,
-		CONFIG_SYS_SDRAM_SIZE);
+	/* dram_init must store complete ramsize in gd->ram_size */
+	gd->ram_size = get_ram_size((void *)PHYS_SDRAM,
+				PHYS_SDRAM_SIZE);
 	return 0;
 }
 
+void dram_init_banksize(void)
+{
+	gd->bd->bi_dram[0].start = PHYS_SDRAM;
+	gd->bd->bi_dram[0].size = PHYS_SDRAM_SIZE;
+}
+
 int board_eth_init(bd_t *bis)
 {
 	int rc = 0;

@@ -140,6 +148,7 @@ int board_eth_init(bd_t *bis)
 	return rc;
 }
 
+#ifdef CONFIG_DISPLAY_BOARDINFO
 int checkboard(void)
 {
 	char str[32];

@@ -173,10 +182,13 @@ int checkboard(void)
 		puts(", serial# ");
 		puts(str);
 	}
+#ifdef CONFIG_REVISION_TAG
 	printf("\nHardware-revision: 1.%d\n", get_hw_rev());
+#endif
 	printf("Mach-type: %lu\n", gd->bd->bi_arch_number);
 	return 0;
 }
+#endif /* CONFIG_DISPLAY_BOARDINFO */
 
 #ifdef CONFIG_SERIAL_TAG
 void get_board_serial(struct tag_serialnr *serialnr)

99 lines not on this page · raw message