Patch "usb: chipidea: debug: disable usb irq while role switch" has been added to the 4.3-stable tree
Subsystems (3)
This is a note to let you know that I've just added the patch titled
usb: chipidea: debug: disable usb irq while role switch
to the 4.3-stable tree which can be found at:
http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary
The filename of the patch is:
usb-chipidea-debug-disable-usb-irq-while-role-switch.patch
and it can be found in the queue-4.3 subdirectory.
If you, or anyone else, feels it should not be added to the stable tree, please let <[email protected]> know about it.
Quoted 1 line
From
251b3c8b57481bcecd3f753108e36e7389ce12acMon Sep 17 00:00:00 2001
From: Li Jun <[email protected]>
Date: Tue, 13 Oct 2015 18:23:31 +0800
Subject: usb: chipidea: debug: disable usb irq while role switch
From: Li Jun <[email protected]>
commit 251b3c8b57481bcecd3f753108e36e7389ce12ac upstream.
Since the ci->role will be set after the host role start is complete, there will be nobody cared irq during start host if usb irq enabled. This error can be reproduced on i.mx6 sololite EVK board by:
1. disable otg id irq(IDIE) and disable all real otg properties of usbotg1 in dts.
2. boot up the board with ID cable and usb device connected.
3. echo gadget > /sys/kernel/debug/ci_hdrc.0/role
4. echo host > /sys/kernel/debug/ci_hdrc.0/role
5. irq 212: nobody cared.
--- drivers/usb/chipidea/debug.c | 2 ++ 1 file changed, 2 insertions(+)
drivers/usb/chipidea/debug.c +2 -0
@@ -322,8 +322,10 @@ static ssize_t ci_role_write(struct filereturn -EINVAL ;pm_runtime_get_sync (ci->dev); +disable_irq (ci->irq);ci_role_stop (ci); ret =ci_role_start (ci, role); +enable_irq (ci->irq);pm_runtime_put_sync (ci->dev);return ret ? ret : count;
Patches currently in stable-queue which might be from [email protected] are
queue-4.3/usb-chipidea-debug-disable-usb-irq-while-role-switch.patch queue-4.3/usb-chipidea-otg-gadget-module-load-and-unload-support.patch