Skip to contentSkip to conversation

USB Mass Storage

DISCUSSION SN 3 participants 4 messages May 12, 2005

lore
Share & tools
lore

SN

author
#0 lore raw

If I use a USB connected hard-disk (IDE), which device driver would I be using? I understand it is recognized as a SCSI disk. So, is it the SCSI driver? Or would the IDE driver be used?

Thanks!

#1 lore raw
Quoted 3 lines · SN

If I use a USB connected hard-disk (IDE), which device driver would I be using? I understand it is recognized as a SCSI disk. So, is it the SCSI driver? Or would the IDE driver be used?

You would use the usb-storage driver which in turn uses the scsi driver.

cmn

Signature · 6 lines
Carlos Martín         http://www.cmartin.tk   http://rpgscript.berlios.de

"I'll wager it's the most extraordinary thing to happen round here
since Queen Elizabeth's handmaid got hit by lightning and sprouted a
beard"
     -- T. C. Boyle, "Water Music"
author
#2 lore raw

Thanks for the reply Carlos and Eshwar.

So is it that IDE (ide-disk.c) doesn't even come into the picture?

Quoted 1 line

From where exactly is the data sent to the disk? I mean, where in

kernel would I find code for read/write on disk?

Thanks in advance.

Regards..

Quoted 16 lines · Carlos Martin
Quoted 3 lines · SN

If I use a USB connected hard-disk (IDE), which device driver would I be using? I understand it is recognized as a SCSI disk. So, is it the SCSI driver? Or would the IDE driver be used?

You would use the usb-storage driver which in turn uses the scsi driver.

cmn
--
Carlos Martín http://www.cmartin.tk http://rpgscript.berlios.de

"I'll wager it's the most extraordinary thing to happen round here since Queen Elizabeth's handmaid got hit by lightning and sprouted a beard"
-- T. C. Boyle, "Water Music"

#3 lore raw
In reply to SN
Quoted 3 lines · SN

If I use a USB connected hard-disk (IDE), which device driver would I be using? I understand it is recognized as a SCSI disk. So, is it the SCSI driver? Or would the IDE driver be used?

It would be the SCSI layer running on top of the USB drivers. No IDE involved on the PC side (obviously the USB enclosure has an IDE controller, but it's driven by the enclsure firmware, not Linux).

-Doug