FAILED: patch "[PATCH] usb: host: xhci-rcar: Avoid long wait in xhci_reset()" failed to apply to 4.5-stable tree

The patch below does not apply to the 4.5-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.

thanks,

greg k-h

------------------ original commit in Linus's tree ------------------

From: Yoshihiro Shimoda <[email protected]>
Date: Fri, 6 May 2016 15:20:11 +0900
Subject: [PATCH] usb: host: xhci-rcar: Avoid long wait in xhci_reset()

The firmware of R-Car USB 3.0 host controller will control the reset. So, if the xhci driver doesn't do firmware downloading (e.g. kernel configuration is CONFIG_USB_XHCI_PLATFORM=y and CONFIG_USB_XHCI_RCAR is not set), the reset of USB 3.0 host controller doesn't work correctly. Then, the host controller will cause long wait in xhci_reset() because the CMD_RESET bit of op_regs->command is not cleared for 10 seconds.

So, this patch modifies the Kconfig to enable both CONFIG_USB_XHCI_PLATFORM and CONFIG_USB_XHCI_RCAR.

index 3050b18b2447..e9d4dde3e9b3 100644
@@ -35,6 +35,7 @@ config USB_XHCI_PCI
 
 config USB_XHCI_PLATFORM
 	tristate "Generic xHCI driver for a platform device"
+	select USB_XHCI_RCAR if ARCH_RENESAS
 	---help---
 	  Adds an xHCI host driver for a generic platform device, which
 	  provides a memory space and an irq.

@@ -63,7 +64,7 @@ config USB_XHCI_MVEBU
 
 config USB_XHCI_RCAR
 	tristate "xHCI support for Renesas R-Car SoCs"
-	select USB_XHCI_PLATFORM
+	depends on USB_XHCI_PLATFORM
 	depends on ARCH_RENESAS || COMPILE_TEST
 	---help---
 	  Say 'Y' to enable the support for the xHCI host controller