Skip to contentSkip to conversation

ARM: dts: Add EMAC AXI settings for Arria10

PATCH Applied [email protected] 2 participants 2 messages Feb 2, 2017 – Feb 3, 2017 Device tree bindings

lore
Share & tools
lore
#0 lore raw

PATCH v2 1/1 ARM: dts: Add EMAC AXI settings for Arria10

From: Thor Thayer <[email protected]>

Add the device tree entries needed to support the EMAC AXI bus settings on the Arria10 SoCFPGA chip.

---
v2 Add the AXI configuration to the other DW EMACs in the chip.

---
 arch/arm/boot/dts/socfpga_arria10.dtsi | 9 +++++++++
 1 file changed, 9 insertions(+)
arch/arm/boot/dts/socfpga_arria10.dtsi +9 -0
index f520cbf..9abc7d8 100644
@@ -400,6 +400,12 @@
 				};
 		};
 
+		socfpga_axi_setup: stmmac-axi-config {
+			snps,wr_osr_lmt = <0xf>;
+			snps,rd_osr_lmt = <0xf>;
+			snps,blen = <0 0 0 0 16 0 0>;
+		};
+
 		gmac0: ethernet at ff800000 {
 			compatible = "altr,socfpga-stmmac", "snps,dwmac-3.72a", "snps,dwmac";
 			altr,sysmgr-syscon = <&sysmgr 0x44 0>;
@@ -416,6 +422,7 @@
 			clock-names = "stmmaceth";
 			resets = <&rst EMAC0_RESET>;
 			reset-names = "stmmaceth";
+			snps,axi-config = <&socfpga_axi_setup>;
 			status = "disabled";
 		};
 
@@ -435,6 +442,7 @@
 			clock-names = "stmmaceth";
 			resets = <&rst EMAC1_RESET>;
 			reset-names = "stmmaceth";
+			snps,axi-config = <&socfpga_axi_setup>;
 			status = "disabled";
 		};
 
@@ -452,6 +460,7 @@
 			rx-fifo-depth = <16384>;
 			clocks = <&l4_mp_clk>;
 			clock-names = "stmmaceth";
+			snps,axi-config = <&socfpga_axi_setup>;
 			status = "disabled";
 		};
 
Signature · 1 line
2.7.4
Applied
#1 lore raw
Quoted 5 lines · On Thu, Feb 2, 2017 at 4:05 PM, <[email protected]> wrote:

From: Thor Thayer <[email protected]>

Add the device tree entries needed to support the EMAC AXI bus settings on the Arria10 SoCFPGA chip.

Quoted 7 lines

---
v2 Add the AXI configuration to the other DW EMACs in the chip.

---
 arch/arm/boot/dts/socfpga_arria10.dtsi | 9 +++++++++
 1 file changed, 9 insertions(+)

Applied!

Thanks,
Dinh