Skip to contentSkip to conversation

igb: Enable reading of wake up packet

PATCH New Chuah 1 participant 3 messages Mar 27, 2017 – Mar 31, 2017

Subsystems (2)
lore
Share & tools
lore

Chuah

#0 lore raw

PATCH 1/1 igb: Enable reading of wake up packet

The Intel i210 NIC supports wake from multiple packet types and stores the wake up packet. However, the current igb driver ignores the Wake Up Status (WUS) and Wake Up Packet Memory (WUPM) registers during resume. This causes the Ethernet controller to drop the packet that caused the wake, causing the remote to time out and having to re-send the packet. This has been seen to cause issues with certain managed-switches, where the switch stops routing packets to the i210-attached host.

This patch enables the igb driver to read the WUPM if the controller was woken by a wake up packet that is not more than 128 bytes long (maximum WUPM size), then pass it up the kernel network stack.

This patch is applied on net-next.

Chuah, Kim Tatt (1):
igb: Enable reading of wake up packet

 drivers/net/ethernet/intel/igb/e1000_defines.h | 21 +++++++++++++++
 drivers/net/ethernet/intel/igb/igb_main.c      | 36 +++++++++++++++++++++++++-
 2 files changed, 56 insertions(+), 1 deletion(-)
Signature · 1 line
1.9.1
#1 lore raw

PATCH 1/1 igb: Enable reading of wake up packet

Currently, in igb_resume(), igb driver ignores the Wake Up Status (WUS) and Wake Up Packet Memory (WUPM) registers. This patch enables the igb driver to read the WUPM if the controller was woken by a wake up packet that is not more than 128 bytes long (maximum WUPM size), then pass it up the kernel network stack.

---
 drivers/net/ethernet/intel/igb/e1000_defines.h | 21 +++++++++++++++
 drivers/net/ethernet/intel/igb/igb_main.c      | 36 +++++++++++++++++++++++++-
 2 files changed, 56 insertions(+), 1 deletion(-)
drivers/net/ethernet/intel/igb/e1000_defines.h +21 -0
index 8aee314..532bc7b 100644
@@ -39,6 +39,27 @@
 #define E1000_WUFC_MC   0x00000008 /* Directed Multicast Wakeup Enable */
 #define E1000_WUFC_BC   0x00000010 /* Broadcast Wakeup Enable */
 
+/* Wake Up Status */
+#define E1000_WUS_EX    0x00000004 /* Directed Exact */
+#define E1000_WUS_ARPD  0x00000020 /* Directed ARP Request */
+#define E1000_WUS_IPV4  0x00000040 /* Directed IPv4 */
+#define E1000_WUS_IPV6  0x00000080 /* Directed IPv6 */
+#define E1000_WUS_NSD   0x00000400 /* Directed IPv6 Neighbor Solicitation */
+
+/* Packet types that are enabled for wake packet delivery */
+#define WAKE_PKT_WUS ( \
+	E1000_WUS_EX   | \
+	E1000_WUS_ARPD | \
+	E1000_WUS_IPV4 | \
+	E1000_WUS_IPV6 | \
+	E1000_WUS_NSD)
+
+/* Wake Up Packet Length */
+#define E1000_WUPL_MASK 0x00000FFF
+
+/* Wake Up Packet Memory stores the first 128 bytes of the wake up packet */
+#define E1000_WUPM_BYTES 128
+
 /* Extended Device Control */
 #define E1000_CTRL_EXT_SDP2_DATA 0x00000040 /* Value of SW Defineable Pin 2 */
 #define E1000_CTRL_EXT_SDP3_DATA 0x00000080 /* Value of SW Defineable Pin 3 */
drivers/net/ethernet/intel/igb/igb_main.c +35 -1
index be456ba..81e0982 100644
@@ -7630,6 +7630,36 @@ static int __igb_shutdown(struct pci_dev *pdev, bool *enable_wake,
 	return 0;
 }
 
+static void igb_deliver_wake_packet(struct net_device *netdev)
+{
+	struct igb_adapter *adapter = netdev_priv(netdev);
+	struct e1000_hw *hw = &adapter->hw;
+	struct sk_buff *skb;
+	u32 wupl;
+
+	wupl = rd32(E1000_WUPL) & E1000_WUPL_MASK;
+
+	/* WUPM stores only the first 128 bytes of the wake packet.
+	 * Read the packet only if we have the whole thing.
+	 */
+	if ((wupl == 0) || (wupl > E1000_WUPM_BYTES))
+		return;
+
+	skb = netdev_alloc_skb_ip_align(netdev, E1000_WUPM_BYTES);
+	if (!skb)
+		return;
+
+	skb_put(skb, wupl);
+
+	/* Ensure reads are 32-bit aligned */
+	wupl = roundup(wupl, 4);
+
+	memcpy_fromio(skb->data, hw->hw_addr + E1000_WUPM_REG(0), wupl);
+
+	skb->protocol = eth_type_trans(skb, netdev);
+	netif_rx(skb);
+}
+
 #ifdef CONFIG_PM
 #ifdef CONFIG_PM_SLEEP
 static int igb_suspend(struct device *dev)
@@ -7659,7 +7689,7 @@ static int igb_resume(struct device *dev)
 	struct net_device *netdev = pci_get_drvdata(pdev);
 	struct igb_adapter *adapter = netdev_priv(netdev);
 	struct e1000_hw *hw = &adapter->hw;
-	u32 err;
+	u32 err, val;
 
 	pci_set_power_state(pdev, PCI_D0);
 	pci_restore_state(pdev);
@@ -7690,6 +7720,10 @@ static int igb_resume(struct device *dev)
 	 */
 	igb_get_hw_control(adapter);
 
+	val = rd32(E1000_WUS);
+	if (val & WAKE_PKT_WUS)
+		igb_deliver_wake_packet(netdev);
+
 	wr32(E1000_WUS, ~0);
 
 	rtnl_lock();
Signature · 1 line
1.9.1
#2 lore raw

PATCH 1/1 igb: Enable reading of wake up packet

Quoted 13 lines

From: Intel-wired-lan [mailto:intel-wired-lan-bounces at lists.osuosl.org] On Behalf Of Chuah, Kim Tatt
Sent: Sunday, March 26, 2017 5:45 PM
To: intel-wired-lan at lists.osuosl.org
Cc: Chuah, Kim Tatt <[email protected]>
Subject: [Intel-wired-lan] [PATCH] igb: Enable reading of wake up packet

Currently, in igb_resume(), igb driver ignores the Wake Up Status (WUS) and Wake Up Packet Memory (WUPM) registers. This patch enables the igb driver to read the WUPM if the controller was woken by a wake up packet that is not more than 128 bytes long (maximum WUPM size), then pass it up the kernel network stack.

Quoted 7 lines
---
 drivers/net/ethernet/intel/igb/e1000_defines.h | 21 +++++++++++++++
 drivers/net/ethernet/intel/igb/igb_main.c      | 36
+++++++++++++++++++++++++-
 2 files changed, 56 insertions(+), 1 deletion(-)