Skip to contentSkip to conversation

2 SCSI controllers causing boot problems...

DISCUSSION Drew Bertola 2 participants 2 messages Feb 2, 2001

lore
Share & tools
lore
#0 lore raw

I know I've seen this in the past, but the answer slips my mind and I can't find anything in the archives.

I've just set up a box w/ an aic7xxx card. The boot drive hangs off that card. During installation, the boot drive is sda. Lilo contains "root=/dev/sda8".

I compiled a new kernel with the 3ware raid driver. When I rebooted, the 3ware card driver must have been loaded first; /dev/sda8 was no longer the root device.

How do I control the device designations during boot?

Signature · 7 lines
Drew Bertola  | Send a text message to my pager or cell ... 
              |   http://jpager.com/Drew

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
#1 lore raw
Quoted 8 lines · On Fri, 02 Feb 2001 10:09:21 Drew Bertola wrote:

I know I've seen this in the past, but the answer slips my mind and I can't find anything in the archives.

I've just set up a box w/ an aic7xxx card. The boot drive hangs off that card. During installation, the boot drive is sda. Lilo contains "root=/dev/sda8".

Quoted 6 lines

I compiled a new kernel with the 3ware raid driver. When I rebooted, the 3ware card driver must have been loaded first; /dev/sda8 was no longer the root device.

How do I control the device designations during boot?

Drew,

If you check the archive's I've had a similar problem.

Possible answers:

Compile the to-be-loaded-2nd driver as a module and keep the first builtin Use devfs (it lets you pass a 'scsi=driver1:driver2:...' to the kernel, controlling load order)

There are devfs 2.2 patches and 2.4.1 includes devfs natively; I chose 2.4.1 and it worked.

--
Michael Pacey
[email protected]
ICQ: 105498469

wd21 ltd - world domination in the 21st century

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/