Skip to contentSkip to conversation

Matrox Marvell G400

DISCUSSION Petr Vandrovec 2 participants 2 messages Feb 5, 2001 – Feb 6, 2001

lore
Share & tools
lore
#0 lore raw
Quoted 7 lines · Gregory Maxwell
Quoted 1 line · Wakko Warner

How well is this card supported for it's capture capabilities and dual head?

Capture and dual head are almost totally unsupported without using a proprietary, binary only driver chunk which will soundly place your system as 'unsupported' as far as this list is concerned due to the difficulty of debugging a system when sourceless software bangs the hardware.

Under X. Under framebuffer both heads of G400 will work for you if it is your primary video devices. For capture capabilities see
http://marvel.sourceforge.net. It for sure worked sometime in the past, but I'm not sure about current state. But I believe that at least watching TV works correctly.

And if you insist on X, you can run first head through mga with usefbdev /dev/fb0 with hwcursor off, and secondary head through fbdev /dev/fb1. But it is not supported by me (and neither by XFree guys AFAIK, not even talking about Matrox support guys) - I support only first head in X and secondary head used for 'fbtv -k'.

Quoted 2 lines

If this situation is not ideals for you, I suggest you address the issue with Matrox.

I'm trying... more or less. Next G450 BIOSes will have fix for matroxfb deadlock on boot, so there is at least some move. Although now when workaround is implemented in matroxfb, it is a bit late...
Best regards,
Petr Vandrovec [email protected]

BTW, under G450 output to TV is not supported and I'm not sure it ever will. Output to second monitor is of course supported.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/

#1 lore raw
Quoted 5 lines · [email protected] said:

And if you insist on X, you can run first head through mga with
usefbdev /dev/fb0 with hwcursor off, and secondary head through fbdev / dev/fb1. But it is not supported by me (and neither by XFree guys AFAIK, not even talking about Matrox support guys) - I support only first head in X and secondary head used for 'fbtv -k'.

Unless your machine is x86, and you use the binary-only HALlib from Matrox, that is. :(

However, since the second heads of both G400 and G450 cards are supported in matroxfb, there's no real reason why the support in the 'real' XFree86 driver should be so far behind. The main barrier to dual-head support in XFree86, last time I knew, was the lack of a way to _configure_ it. That's now been fixed, obviously. The HALlib is used only for mode setup, AFAICT. All acceleration is still done by the real driver.

Petr - how much of the matroxfb code is yours to give, and would you permit chunks of it to be reused under the XFree86 licence? Clean-room reverse-engineering is such a PITA :)

Quoted 3 lines

I'm trying... more or less. Next G450 BIOSes will have fix for matroxfb deadlock on boot, so there is at least some move. Although now when workaround is implemented in matroxfb, it is a bit late...

I think that workaround wants to be put in place for G400 too; not just G450.

--
dwmw2

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/