VIA silent disk corruption - bad news
Quoted 16 lines · Udo A. Steinberg
Quoted 6 lines · Petr Vandrovec
Quoted 4 lines · Udo A. Steinberg
00:00.0 Host bridge: VIA Technologies, Inc.: Unknown device 0305 (rev 02)
Subsystem: Asustek Computer, Inc.: Unknown device 8033
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=mediumQuoted 8 lines
>TAbort- <TAbort- <MAbort+ >SERR- <PERR+
^^^^^^
I tried all different settings in BIOS, and I even programmed values from your lspci to my VIA (except for SDRAM timmings) - and although it is a bit better, it is not still perfect.So for today I'm back on [UMS]DMA disabled. I'll try downgrading BIOS today, but it looks to me like that something is severely broken here.
Quoted 6 lines
Are your drives connected to the VIA or the Promise controller? Mine are both connected to the PDC20265 and running in UDMA-100 mode. There have been several threads on lkml about corruption on disks connected to Via chipset IDE controllers, although I didn't follow them in great detail. Maybe your problem is not related to the host bridge, but to the IDE controller?
They are connected to Promise, I reserved VIA for CDROM drive. One HDD runs in UDMA5 mode, another in UDMA2. Corruption is often when I run md5sum in parallel on both HDDs - in that case almost no file generates same checksum which was generated using PIO4. When I run md5sum on only one HDD, there are about 4 checksum errors in 6GB of data. But I'm more and more inclined to throw this A7V away, as it is impossible to get datasheet from Promise, and for VIA host bridge I was just able to slow down normal system operation by factor of 3... but still with same corruption :-( Just if page could have 4092 and not 4096 bytes ;-)
Petr
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/