acpi: apei: call into AER handling regardless of severity

Currently the GHES code only calls into the AER driver for recoverable type errors. This is incorrect because errors of other severities do not get logged by the AER driver and do not get exposed to user space via the AER trace event. So, call into the AER driver for PCIe errors regardless of the severity.

Signed-off-by Tyler Baicar <[email protected]>

---
  drivers/acpi/apei/ghes.c | 76 +++++++++++++++++++++++++++++-------------------
  1 file changed, 46 insertions(+), 30 deletions(-)

drivers/acpi/apei/ghes.c +46 -30

index 3c3a37b..d7801bc 100644
@@ -458,6 +458,51 @@ static void ghes_handle_memory_failure(struct acpi_hest_generic_data *gdata, int
  #endif
  }
 
+/*
+ * PCIe AER errors need to be sent to the AER driver for reporting and
+ * recovery. The GHES severities map to the following AER severities and
+ * require the following handling:
+ *
+ * GHES_SEV_CORRECTABLE -> AER_CORRECTABLE
+ *	These need to be reported by the AER driver but no recovery is
+ *	necessary.
+ * GHES_SEV_RECOVERABLE -> AER_NONFATAL
+ * GHES_SEV_RECOVERABLE && CPER_SEC_RESET -> AER_FATAL
+ *	These both need to be reported and recovered from by the AER driver.
+ * GHES_SEV_PANIC does not make it to this handling since the kernel must
+ *	panic.
+ */
+static void ghes_handle_aer(struct acpi_hest_generic_data *gdata)
+{
+#ifdef CONFIG_ACPI_APEI_PCIEAER
+	struct cper_sec_pcie *pcie_err = acpi_hest_get_payload(gdata);
+
+	if (pcie_err->validation_bits & CPER_PCIE_VALID_DEVICE_ID &&
+	    pcie_err->validation_bits & CPER_PCIE_VALID_AER_INFO) {
+		unsigned int devfn;
+		int aer_severity;
+
+		devfn = PCI_DEVFN(pcie_err->device_id.device,
+				  pcie_err->device_id.function);
+		aer_severity = cper_severity_to_aer(gdata->error_severity);
+
+		/*
+		 * If firmware reset the component to contain
+		 * the error, we must reinitialize it before
+		 * use, so treat it as a fatal AER error.
+		 */
+		if (gdata->flags & CPER_SEC_RESET)
+			aer_severity = AER_FATAL;
+
+		aer_recover_queue(pcie_err->device_id.segment,
+				  pcie_err->device_id.bus,
+				  devfn, aer_severity,
+				  (struct aer_capability_regs *)
+				  pcie_err->aer_info);
+	}
+#endif
+}
+
  static void ghes_do_proc(struct ghes *ghes,
  			 const struct acpi_hest_generic_status *estatus)
  {

@@ -485,38 +530,9 @@ static void ghes_do_proc(struct ghes *ghes,
  			arch_apei_report_mem_error(sev, mem_err);
  			ghes_handle_memory_failure(gdata, sev);
  		}
-#ifdef CONFIG_ACPI_APEI_PCIEAER
  		else if (guid_equal(sec_type, &CPER_SEC_PCIE)) {
-			struct cper_sec_pcie *pcie_err = acpi_hest_get_payload(gdata);
-
-			if (sev == GHES_SEV_RECOVERABLE &&
-			    sec_sev == GHES_SEV_RECOVERABLE &&
-			    pcie_err->validation_bits & CPER_PCIE_VALID_DEVICE_ID &&
-			    pcie_err->validation_bits & CPER_PCIE_VALID_AER_INFO) {
-				unsigned int devfn;
-				int aer_severity;
-
-				devfn = PCI_DEVFN(pcie_err->device_id.device,
-						  pcie_err->device_id.function);
-				aer_severity = cper_severity_to_aer(gdata->error_severity);
-
-				/*
-				 * If firmware reset the component to contain
-				 * the error, we must reinitialize it before
-				 * use, so treat it as a fatal AER error.
-				 */
-				if (gdata->flags & CPER_SEC_RESET)
-					aer_severity = AER_FATAL;
-
-				aer_recover_queue(pcie_err->device_id.segment,
-						  pcie_err->device_id.bus,
-						  devfn, aer_severity,
-						  (struct aer_capability_regs *)
-						  pcie_err->aer_info);
-			}
-
+			ghes_handle_aer(gdata);
  		}
-#endif
  		else if (guid_equal(sec_type, &CPER_SEC_PROC_ARM)) {
  			struct cper_sec_proc_arm *err = acpi_hest_get_payload(gdata);
 

Do you think this patch is good now?