Patch "qed: Align CIDs according to DORQ requirement" has been added to the 4.9-stable tree
Subsystems (3)
This is a note to let you know that I've just added the patch titled
qed: Align CIDs according to DORQ requirement
to the 4.9-stable tree which can be found at:
http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary
The filename of the patch is:
qed-align-cids-according-to-dorq-requirement.patch
and it can be found in the queue-4.9 subdirectory.
If you, or anyone else, feels it should not be added to the stable tree, please let <[email protected]> know about it.
Quoted 1 line
From foo@baz Mon Dec 18 14:12:34 CET 2017
From: Ram Amrani <[email protected]>
Date: Tue, 14 Mar 2017 15:25:58 +0200
Subject: qed: Align CIDs according to DORQ requirement
From: Ram Amrani <[email protected]>
[ Upstream commit f3e48119b97f56fb09310c95d49da122a27003d7 ]
The Doorbell HW block can be configured at a granularity of 16 x CIDs, so we need to make sure that the actual number of CIDs configured would be a multiplication of 16.
Today, when RoCE is enabled - given that the number is unaligned, doorbelling the higher CIDs would fail to reach the firmware and would eventually timeout.
--- drivers/net/ethernet/qlogic/qed/qed_cxt.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
drivers/net/ethernet/qlogic/qed/qed_cxt.c +2 -1
@@ -373,8 +373,9 @@ static void qed_cxt_set_proto_cid_count(u32 page_sz = p_mgr->clients[ILT_CLI_CDUC ].p_size.val;u32 cxt_size =CONN_CXT_SIZE (p_hwfn);u32 elems_per_page =ILT_PAGE_IN_BYTES (page_sz) / cxt_size; +u32 align = elems_per_page *DQ_RANGE_ALIGN ; - p_conn->cid_count =roundup (p_conn->cid_count, elems_per_page); + p_conn->cid_count =roundup (p_conn->cid_count, align); } }
Patches currently in stable-queue which might be from [email protected] are
queue-4.9/qed-fix-interrupt-flags-on-rx-ll2.patch queue-4.9/qed-align-cids-according-to-dorq-requirement.patch