Skip to contentSkip to conversation

how to Relocate arm startup code

U-Boot-Users Hebbar 1 participant 1 message Feb 12, 2008

lore
Share & tools
lore

Hebbar

author
#0 lore raw

Hi,

I am working on a customized arm926ejs versatile board. My board has SDRAM at reset vector i.e., @ 0x00 and FLASH is located at a different higher lcoation. At Boot up, SDRAm is mapped to Flash. I have to enable few register and enable sdram chip. @ reset the arm uboot startup code has

b reset

which point to TEXT_BASE + 0x50 which in my case falls to uninitialized SDRAM and hence it fails. So i have to hard code the startup to point to my flash location. so

Instead of
b reset

i have
ldr pc, _flash_reset

where
_flash_reset:
.word (CFG_FLASH_BASE + reset - TEXT_BASE)

So i want to know if there is any better alternative to this instead of hard coding. Also i would like to know how this taken care of for versatile board.

Regards
Gururaja

Signature · 2 lines
View this message in context: http://www.nabble.com/how-to-Relocate-arm-startup-code-tp15424226p15424226.html
Sent from the Uboot - Users mailing list archive at Nabble.com.