dt-bindings: input: touchscreen: iqs5xx: Add bindings
Subsystems (2)
PATCH v4 1/2 dt-bindings: input: touchscreen: iqs5xx: Add bindings
This patch adds binding documentation for the Azoteq IQS550/572/525 family of trackpad/touchscreen controllers.
---
Changes in v4:
- None
Changes in v3:
- Added Reviewed-by trailer
Changes in v2:
- Separated each valid "compatible" property with a line break
- Specified the polarity of the RDY and NRST pins
- Replaced duplicate definitions of common touchscreen properties with a reference to touchscreen.txt
- Specified the example node as "touchscreen@74"
.../bindings/input/touchscreen/iqs5xx.txt | 109 +++++++++++++++++++++ .../devicetree/bindings/vendor-prefixes.txt | 1 + 2 files changed, 110 insertions(+) create mode 100644 Documentation/devicetree/bindings/input/touchscreen/iqs5xx.txt
Documentation/devicetree/bindings/input/touchscreen/iqs5xx.txt new file +109 -0
@@ -0,0 +1,109 @@ +Azoteq IQS550/572/525 Trackpad/Touchscreen Controller + +Required properties: + +- compatible : Must be equal to one of the following: + "azoteq,iqs550" + "azoteq,iqs572" + "azoteq,iqs525" + +- reg : I2C slave address for the device. + +- interrupts : GPIO to which the device's active-high RDY + output is connected (see [0]). + +- reset-gpios : GPIO to which the device's active-low NRST + input is connected (see [1]). Hardware reset + access is required in order to to facilitate + in-system firmware replacement. + +Optional properties: + +- azoteq,exp-ver-major : Major field of the export file version number + (0 through 255 inclusive). This property must + be specified as a '/bits/ 8' value. + +- azoteq,exp-ver-minor : Minor field of the export file version number + (0 through 255 inclusive). This property must + be specified as a '/bits/ 8' value. + + The export file version number is a customer- + assigned parameter embedded in the device's + firmware at the time it is exported from the + manufacturer's PC-based configuration tool. + + If the export file version number stored in + the device's nonvolatile memory does not match + the number specified here, the driver replaces + the firmware on the device with that which is + stored on the local filesystem (for which the + export file version number must match). + + If both major and minor fields are omitted or + specified as zero, the driver does not query + the device's export file version number. + +- touchscreen-min-x : See [2]. + +- touchscreen-min-y : See [2]. + +- touchscreen-size-x : See [2]. If this property is omitted, the + maximum x-coordinate is specified by the + device's "X Resolution" register. + +- touchscreen-size-y : See [2]. If this property is omitted, the + maximum y-coordinate is specified by the + device's "Y Resolution" register. + +- touchscreen-max-pressure : See [2]. Pressure is expressed as the sum of + the deltas across all channels impacted by a + touch event. A channel's delta is calculated + as its count value minus a reference, where + the count value is inversely proportional to + the channel's capacitance. + +- touchscreen-fuzz-x : See [2]. + +- touchscreen-fuzz-y : See [2]. + +- touchscreen-fuzz-pressure : See [2]. + +- touchscreen-inverted-x : See [2]. Inversion is applied relative to that + which may already be specified by the device's + FLIP_X and FLIP_Y register fields. + +- touchscreen-inverted-y : See [2]. Inversion is applied relative to that + which may already be specified by the device's + FLIP_X and FLIP_Y register fields. + +- touchscreen-swapped-x-y : See [2]. Swapping is applied relative to that + which may already be specified by the device's + SWITCH_XY_AXIS register fields. + +[0]: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt +[1]: Documentation/devicetree/bindings/gpio/gpio.txt +[2]: Documentation/devicetree/bindings/input/touchscreen/touchscreen.txt + +Example: + + &i2c1 { + /* ... */ + + touchscreen@74 { + compatible = "azoteq,iqs550"; + reg = <0x74>; + interrupt-parent = <&gpio>; + interrupts = <17 1>; + reset-gpios = <&gpio 27 0>; + + azoteq,exp-ver-major = /bits/ 8 <1>; + azoteq,exp-ver-minor = /bits/ 8 <0>; + + touchscreen-size-x = <640>; + touchscreen-size-y = <480>; + + touchscreen-max-pressure = <16000>; + }; + + /* ... */ + };
Documentation/devicetree/bindings/vendor-prefixes.txt +1 -0
@@ -49,6 +49,7 @@ avia avia semiconductor avic Shanghai AVIC Optoelectronics Co., Ltd. axentia Axentia Technologies AB axis Axis Communications AB +azoteq Azoteq (Pty) Ltd bananapi BIPAI KEJI LIMITED bhf Beckhoff Automation GmbH & Co. KG boe BOE Technology Group Co., Ltd.
--
2.7.4
PATCH v4 2/2 input: touchscreen: Add support for Azoteq IQS550/572/525
This patch adds support for the Azoteq IQS550/572/525 family of trackpad/touchscreen controllers.
---
Changes in v4:
- Replaced 'ret' with 'error' where applicable
- Made use of packed structures to parse device ID and touch data registers as well as firmware records
- Overhauled iqs5xx_update_firmware to make use of existing helper functions and to be robust against erroneous firmware files
- Refactored and fortified the bootloader steps in iqs5xx_update_firmware by allowing additional retries upon failure
- Optimized register read/write functions and added wrappers for single-byte transactions
- Updated the error handling in iqs5xx_set_state and removed the superfluous 'disabled' flag
- General improvements to error messages returned via dev_err
Changes in v3:
- None
Changes in v2:
- Rebased on top of updated iqs5xx.txt
- Refactored the axis configuration logic in iqs5xx_dev_init to adhere to the behavior defined in touchscreen.txt
drivers/input/touchscreen/Kconfig | 10 + drivers/input/touchscreen/Makefile | 1 + drivers/input/touchscreen/iqs5xx.c | 1014 ++++++++++++++++++++++++++++++++++++ 3 files changed, 1025 insertions(+) create mode 100644 drivers/input/touchscreen/iqs5xx.c
drivers/input/touchscreen/Kconfig +10 -0
@@ -1298,4 +1298,14 @@ config TOUCHSCREEN_ROHM_BU21023 To compile this driver as a module, choose M here: the module will be called bu21023_ts. +config TOUCHSCREEN_IQS5XX + tristate "Azoteq IQS550/572/525 trackpad/touchscreen controller" + depends on I2C + help + Say Y to enable support for the Azoteq IQS550/572/525 + family of trackpad/touchscreen controllers. + + To compile this driver as a module, choose M here: the + module will be called iqs5xx. + endif
drivers/input/touchscreen/Makefile +1 -0
@@ -109,3 +109,4 @@ obj-$(CONFIG_TOUCHSCREEN_ZFORCE) += zforce_ts.o obj-$(CONFIG_TOUCHSCREEN_COLIBRI_VF50) += colibri-vf50-ts.o obj-$(CONFIG_TOUCHSCREEN_ROHM_BU21023) += rohm_bu21023.o obj-$(CONFIG_TOUCHSCREEN_RASPBERRYPI_FW) += raspberrypi-ts.o +obj-$(CONFIG_TOUCHSCREEN_IQS5XX) += iqs5xx.o
drivers/input/touchscreen/iqs5xx.c new file +1014 -0
1,014 lines not on this page · raw message
--
2.7.4