ath10k: reduce transmit msdu count
PATCH 1/1 ath10k: reduce transmit msdu count
From: Alagu Sankar <[email protected]>
Reduce the transmit MSDU count for SDIO, to match with the descriptors as used by the firmware. This also acts as a high watermark level for transmit. Too many packets to the firmware results in transmit overflow interrupt.
It only affect SDIO chip, it will not cause functionaly changes to other hardware.
Tested with QCA6174 SDIO with firmware
WLAN.RMH.4.4.1-00005-QCARMSWP-1.
--- drivers/net/wireless/ath/ath10k/core.c | 6 +++++- drivers/net/wireless/ath/ath10k/hw.h | 1 + drivers/net/wireless/ath/ath10k/wmi-tlv.c | 2 +- 3 files changed, 7 insertions(+), 2 deletions(-)
drivers/net/wireless/ath/ath10k/core.c +5 -1
@@ -2309,7 +2309,11 @@ static int ath10k_core_init_firmware_features(struct ath10k *ar) ar->max_num_stations =TARGET_TLV_NUM_STATIONS ; ar->max_num_vdevs =TARGET_TLV_NUM_VDEVS ; ar->max_num_tdls_vdevs =TARGET_TLV_NUM_TDLS_VDEVS ; - ar->htt.max_num_pending_tx =TARGET_TLV_NUM_MSDU_DESC ; +if (ar->hif.bus ==ATH10K_BUS_SDIO ) + ar->htt.max_num_pending_tx = +TARGET_TLV_NUM_MSDU_DESC_HL ; +else + ar->htt.max_num_pending_tx =TARGET_TLV_NUM_MSDU_DESC ; ar->wow.max_num_patterns =TARGET_TLV_NUM_WOW_PATTERNS ; ar->fw_stats_req_mask =WMI_STAT_PDEV |WMI_STAT_VDEV |WMI_STAT_PEER ;
drivers/net/wireless/ath/ath10k/hw.h +1 -0
@@ -724,6 +724,7 @@ struct ath10k_hw_ops {#define TARGET_TLV_NUM_TDLS_VDEVS 1#define TARGET_TLV_NUM_TIDS ((TARGET_TLV_NUM_PEERS) * 2)#define TARGET_TLV_NUM_MSDU_DESC (1024 + 32) +#define TARGET_TLV_NUM_MSDU_DESC_HL 64#define TARGET_TLV_NUM_WOW_PATTERNS 22#define TARGET_TLV_MGMT_NUM_MSDU_DESC (50)
drivers/net/wireless/ath/ath10k/wmi-tlv.c +1 -1
@@ -1611,7 +1611,7 @@ static struct sk_buff *ath10k_wmi_tlv_op_gen_init(struct ath10k *ar) cfg->rx_skip_defrag_timeout_dup_detection_check =__cpu_to_le32 (0 ); cfg->vow_config =__cpu_to_le32 (0 ); cfg->gtk_offload_max_vdev =__cpu_to_le32 (2 ); - cfg->num_msdu_desc =__cpu_to_le32 (TARGET_TLV_NUM_MSDU_DESC ); + cfg->num_msdu_desc =__cpu_to_le32 (ar->htt.max_num_pending_tx); cfg->max_frag_entries =__cpu_to_le32 (2 ); cfg->num_tdls_vdevs =__cpu_to_le32 (TARGET_TLV_NUM_TDLS_VDEVS ); cfg->num_tdls_conn_table_entries =__cpu_to_le32 (0x20 );
Signature · 7 lines
1.9.1 _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
Quoted 8 lines · Wen Gong
Reduce the transmit MSDU count for SDIO, to match with the descriptors as used by the firmware. This also acts as a high watermark level for transmit. Too many packets to the firmware results in transmit overflow interrupt.
It only affect SDIO chip, it will not cause functionaly changes to other hardware.
Quoted 6 lines
Tested with QCA6174 SDIO with firmware
WLAN.RMH.4.4.1-00005-QCARMSWP-1.Signed-off-by Alagu Sankar <[email protected]>Signed-off-by Wen Gong <[email protected]>Signed-off-by Kalle Valo <[email protected]>
Patch applied to ath-next branch of ath.git, thanks.
a73dbce3a6f4 ath10k: reduce transmit msdu count
Signature · 9 lines
https://patchwork.kernel.org/patch/10791705/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
Quoted 8 lines · Wen Gong
Reduce the transmit MSDU count for SDIO, to match with the descriptors as used by the firmware. This also acts as a high watermark level for transmit. Too many packets to the firmware results in transmit overflow interrupt.
It only affect SDIO chip, it will not cause functionaly changes to other hardware.
Quoted 6 lines
Tested with QCA6174 SDIO with firmware
WLAN.RMH.4.4.1-00005-QCARMSWP-1.Signed-off-by Alagu Sankar <[email protected]>Signed-off-by Wen Gong <[email protected]>Signed-off-by Kalle Valo <[email protected]>
Patch applied to ath-next branch of ath.git, thanks.
a73dbce3a6f4 ath10k: reduce transmit msdu count
Signature · 3 lines
https://patchwork.kernel.org/patch/10791705/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches