ARM: dts: at91: sama5d2: disable pwm0 by default
Subsystems (3)
PATCH 1/4 ARM: dts: at91: sama5d2: disable pwm0 by default
From: Razvan Stefanescu <[email protected]>
It will be enabled as needed by each board.
--- arch/arm/boot/dts/sama5d2.dtsi | 1 + 1 file changed, 1 insertion(+)
arch/arm/boot/dts/sama5d2.dtsi +1 -0
@@ -615,6 +615,7 @@ interrupts = <38 IRQ_TYPE_LEVEL_HIGH 7>; #pwm-cells = <3>; clocks = <&pmc PMC_TYPE_PERIPHERAL 38>; + status = "disabled"; }; sfr: sfr@f8030000 {
Signature · 1 line
2.7.4
PATCH 2/4 ARM: dts: at91: sama5d2: mark secumod as a GPIO controller
From: Andrei Stefanescu <[email protected]>
The Security Module exposes the PIOBU pins which an be used as regular GPIOs. The PIOBU pins are special because they do not lose their voltage during suspend-to-mem.
This patch marks the secumod as a GPIO controller.
--- arch/arm/boot/dts/sama5d2.dtsi | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-)
arch/arm/boot/dts/sama5d2.dtsi +4 -1
@@ -885,9 +885,12 @@ clocks = <&pmc PMC_TYPE_PERIPHERAL 18>; }; - secumod@fc040000 { + pioBU: secumod@fc040000 { compatible = "atmel,sama5d2-secumod", "syscon"; reg = <0xfc040000 0x100>; + + gpio-controller; + #gpio-cells = <2>; }; tdes@fc044000 {
Signature · 1 line
2.7.4
PATCH 3/4 dt-bindings: ARM: at91: Document SAMA5D27 WLSOM1 and Evaluation Kit
In reply to [email protected]From: Eugen Hristev <[email protected]>
Document device tree binding of SAMA5D27 WLSOM1 - Wireless module; and SAMA5D27 WLSOM1 EK - Wireless module evaluation kit, from Microchip.
--- Documentation/devicetree/bindings/arm/atmel-at91.yaml | 15 +++++++++++++++ 1 file changed, 15 insertions(+)
Documentation/devicetree/bindings/arm/atmel-at91.yaml +15 -0
@@ -52,6 +52,21 @@ properties: - const: atmel,sama5d2 - const: atmel,sama5 + - description: Microchip SAMA5D27 WLSOM1 + items: + - const: microchip,sama5d27-wlsom1 + - const: atmel,sama5d27 + - const: atmel,sama5d2 + - const: atmel,sama5 + + - description: Microchip SAMA5D27 WLSOM1 Evaluation Kit + items: + - const: microchip,sama5d27-wlsom1-ek + - const: microchip,sama5d27-wlsom1 + - const: atmel,sama5d27 + - const: atmel,sama5d2 + - const: atmel,sama5 + - items: - const: atmel,sama5d27 - const: atmel,sama5d2
Signature · 1 line
2.7.4
Re: [PATCH 3/4] dt-bindings: ARM: at91: Document SAMA5D27 WLSOM1 and Evaluation Kit
Quoted 11 lines · On Tue, 12 Nov 2019 07:19:54 +0000, <[email protected]> wrote:
From: Eugen Hristev <[email protected]>
Document device tree binding of SAMA5D27 WLSOM1 - Wireless module; and SAMA5D27 WLSOM1 EK - Wireless module evaluation kit, from Microchip.
Signed-off-by Eugen Hristev <[email protected]>--- Documentation/devicetree/bindings/arm/atmel-at91.yaml | 15 +++++++++++++++ 1 file changed, 15 insertions(+)
PATCH 4/4 ARM: dts: at91: sama5d27_wlsom1: add SAMA5D27 wlsom1 and wlsom1-ek
In reply to [email protected]From: Eugen Hristev <[email protected]>
This is the addition of a new Evaluation Kit the SAMA5D27-WLSOM1-EK. It's based on the Microchip WireLess SoM which contains the SAMA5D27 LPDDR2 2Gbits SiP.
[[email protected]]: initial implementation
[[email protected]]: ported to new kernel version, [[email protected]]: addition of peripherals (adc, pmic, qspi, uart)
--- arch/arm/boot/dts/Makefile | 1 + arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi | 304 ++++++++++++++++++++++++++ arch/arm/boot/dts/at91-sama5d27_wlsom1_ek.dts | 270 +++++++++++++++++++++++ 3 files changed, 575 insertions(+) create mode 100644 arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi create mode 100644 arch/arm/boot/dts/at91-sama5d27_wlsom1_ek.dts
arch/arm/boot/dts/Makefile +1 -0
@@ -49,6 +49,7 @@ dtb-$(CONFIG_SOC_SAM_V7) += \ at91-kizbox3-hs.dtb \ at91-nattis-2-natte-2.dtb \ at91-sama5d27_som1_ek.dtb \ + at91-sama5d27_wlsom1_ek.dtb \ at91-sama5d2_ptc_ek.dtb \ at91-sama5d2_xplained.dtb \ at91-sama5d3_xplained.dtb \
arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi new file +304 -0
304 lines not on this page · raw message
arch/arm/boot/dts/at91-sama5d27_wlsom1_ek.dts new file +270 -0
270 lines not on this page · raw message
Signature · 1 line
2.7.4