Skip to contentSkip to conversation

starfire reads irq before pci_enable_device.

PATCH Petr Vandrovec 2 participants 2 messages Feb 14, 2001 – Feb 15, 2001

lore
Share & tools
lore
#0 lore raw
Quoted 10 lines · Jes Sorensen
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line

"Donald" == Donald Becker <[email protected]> writes:

Donald> On 12 Feb 2001, Jes Sorensen wrote:

Donald> ??? - It's not just IPX hosts that send 802.3 headers. - Donald> While a good initial value might depend on the architecture, Donald> the best setting is processor implementation and environment Donald> dependent. Those details are not known at compile time. - Donald> The code path cost of a module option is only a compare and a Donald> conditional branch.

Quoted 5 lines

What else is sending out 802.3 frames these days? I really don't care about IPX when it comes to performance.

I am just advocating that we optimize for the common case which is DIX frames and not 802.3.

Pardon me, but IPX in 802.3 and IPX in DIX are exactly same frames on wire, except that IPX/802.3 contains frame length in bytes 0x0C/0x0D, while IPX/DIX contains 0x8137 here. They have same length, and same length of media header, so I really do not understand.

If you are talking about encapsulation which is known as `ethernet_802.2' in IPX world, then it is true, it has odd bytes in header. But nobody sane except Appletalk uses 802.2 now... Our Suns already died due to this couple of years ago ;-)

And as Ethernet SNAP has 8byte long header, it should be safe too, unless architecture requires 16byte alignment - so only odd 802.2 should be baned.
Best regards,
Petr Vandrovec [email protected]

#1 lore raw
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line

"Petr" == Petr Vandrovec <[email protected]> writes:

Quoted 5 lines · Jes Sorensen
Quoted 5 lines

What else is sending out 802.3 frames these days? I really don't
care about IPX when it comes to performance.

I am just advocating that we optimize for the common case which is DIX frames and not 802.3.

Petr> Pardon me, but IPX in 802.3 and IPX in DIX are exactly same Petr> frames on wire, except that IPX/802.3 contains frame length in Petr> bytes 0x0C/0x0D, while IPX/DIX contains 0x8137 here. They have Petr> same length, and same length of media header, so I really do not Petr> understand.

Petr> If you are talking about encapsulation which is known as Petr> `ethernet_802.2' in IPX world, then it is true, it has odd bytes Petr> in header. But nobody sane except Appletalk uses 802.2 Petr> now... Our Suns already died due to this couple of years ago ;-)

My point is that you rarely see Ethernet frames with 802.3 except for places running IPX.

Jes