patch "staging: iio: ad2s1210: Fix SPI reading" added to staging-linus

This is a note to let you know that I've just added the patch titled

staging: iio: ad2s1210: Fix SPI reading

to my staging git tree which can be found at
git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/staging.git
in the staging-linus branch.

The patch will show up in the next release of the linux-next tree (usually sometime within the next 24 hours during the week.)

The patch will hopefully also be merged in Linus's tree for the next -rc kernel release.

If you have any questions about this process, please let me know.

From 5e4f99a6b788047b0b8a7496c2e0c8f372f6edf2 Mon Sep 17 00:00:00 2001
From: Dragos Bogdan <[email protected]>
Date: Wed, 29 Apr 2020 10:21:29 +0300
Subject: staging: iio: ad2s1210: Fix SPI reading

If the serial interface is used, the 8-bit address should be latched using the rising edge of the WR/FSYNC signal.

This basically means that a CS change is required between the first byte sent, and the second one.
This change splits the single-transfer transfer of 2 bytes into 2 transfers with a single byte, and CS change in-between.

Note fixes tag is not accurate, but reflects a point beyond which there are too many refactors to make backporting straight forward.

---
 drivers/staging/iio/resolver/ad2s1210.c | 17 ++++++++++++-----
 1 file changed, 12 insertions(+), 5 deletions(-)

index 4b25a3a314ed..ed404355ea4c 100644
@@ -130,17 +130,24 @@ static int ad2s1210_config_write(struct ad2s1210_state *st, u8 data)
 static int ad2s1210_config_read(struct ad2s1210_state *st,
 				unsigned char address)
 {
-	struct spi_transfer xfer = {
-		.len = 2,
-		.rx_buf = st->rx,
-		.tx_buf = st->tx,
+	struct spi_transfer xfers[] = {
+		{
+			.len = 1,
+			.rx_buf = &st->rx[0],
+			.tx_buf = &st->tx[0],
+			.cs_change = 1,
+		}, {
+			.len = 1,
+			.rx_buf = &st->rx[1],
+			.tx_buf = &st->tx[1],
+		},
 	};
 	int ret = 0;
 
 	ad2s1210_set_mode(MOD_CONFIG, st);
 	st->tx[0] = address | AD2S1210_MSB_IS_HIGH;
 	st->tx[1] = AD2S1210_REG_FAULT;
-	ret = spi_sync_transfer(st->sdev, &xfer, 1);
+	ret = spi_sync_transfer(st->sdev, xfers, 2);
 	if (ret < 0)
 		return ret;
 

2.26.2