Skip to contentSkip to conversation

usb: dwc3: Increase timeout for CmdAct cleared by device controller

PATCH New Li Jun 1 participant 1 message May 21, 2020

Subsystems (2)
lore
Share & tools
lore

Li Jun

author
#0 lore raw

PATCH 1/1 usb: dwc3: Increase timeout for CmdAct cleared by device controller

From: Yu Chen <[email protected]>

If the SS PHY is in P3, there is no pipe_clk, HW may use suspend_clk for function, as suspend_clk is slow so EP command need more time to complete, e.g, imx8M suspend_clk is 32K, set ep configuration will take about 380us per below trace time stamp(44.286278 - 44.285897 = 0.000381):

configfs_acm.sh-822 [000] d..1 44.285896: dwc3_writel: addr
000000006d59aae1 value 00000401
configfs_acm.sh-822 [000] d..1 44.285897: dwc3_readl: addr
000000006d59aae1 value 00000401
... ...
configfs_acm.sh-822 [000] d..1 44.286278: dwc3_readl: addr
000000006d59aae1 value 00000001
configfs_acm.sh-822 [000] d..1 44.286279: dwc3_gadget_ep_cmd:
ep0out: cmd 'Set Endpoint Configuration' [401] params 00001000 00000500 00000000 --> status: Successful

This was originally found on Hisilicon Kirin Soc that need more time for the device controller to clear the CmdAct of DEPCMD.

---
 drivers/usb/dwc3/gadget.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/usb/dwc3/gadget.c +1 -1
index fea4fde..7739fe0 100644
@@ -273,7 +273,7 @@ int dwc3_send_gadget_ep_cmd(struct dwc3_ep *dep, unsigned cmd,
 {
 	const struct usb_endpoint_descriptor *desc = dep->endpoint.desc;
 	struct dwc3		*dwc = dep->dwc;
-	u32			timeout = 1000;
+	u32			timeout = 5000;
 	u32			saved_config = 0;
 	u32			reg;
 
Signature · 1 line
2.7.4