rainier: Add leds that are off 9551 on Operator Panel
Subsystems (2)
PATCH 1/2 rainier: Add leds that are off 9551 on Operator Panel
From: Vishwanatha Subbanna <[email protected]>
These are LEDs that are controlled by 9551
Signed-off-by Vishwanatha Subbanna <[email protected]>
Reviewed-by Eddie James <[email protected]>
--- arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts | 82 ++++++++++++++++++++++++++++ 1 file changed, 82 insertions(+)
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts +82 -0
@@ -120,6 +120,38 @@ reg = <3>; }; }; + + leds { + compatible = "gpio-leds"; + + /* System ID LED that is at front on Op Panel */ + front-sys-id0 { + retain-state-shutdown; + default-state = "keep"; + gpios = <&pca1 0 GPIO_ACTIVE_LOW>; + }; + + /* System Attention Indicator ID LED that is at front on Op Panel */ + front-check-log0 { + retain-state-shutdown; + default-state = "keep"; + gpios = <&pca1 1 GPIO_ACTIVE_LOW>; + }; + + /* Enclosure Fault LED that is at front on Op Panel */ + front-enc-fault1 { + retain-state-shutdown; + default-state = "keep"; + gpios = <&pca1 2 GPIO_ACTIVE_LOW>; + }; + + /* System PowerOn LED that is at front on Op Panel */ + front-sys-pwron0 { + retain-state-shutdown; + default-state = "keep"; + gpios = <&pca1 3 GPIO_ACTIVE_LOW>; + }; + }; }; &ehci1 {
@@ -816,6 +848,56 @@ }; }; + pca1: pca9551@60 { + compatible = "nxp,pca9551"; + reg = <0x60>; + #address-cells = <1>; + #size-cells = <0>; + + gpio-controller; + #gpio-cells = <2>; + + gpio@0 { + reg = <0>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@1 { + reg = <1>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@2 { + reg = <2>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@3 { + reg = <3>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@4 { + reg = <4>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@5 { + reg = <5>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@6 { + reg = <6>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@7 { + reg = <7>; + type = <PCA955X_TYPE_GPIO>; + }; + }; + dps: dps310@76 { compatible = "infineon,dps310"; reg = <0x76>;
Signature · 1 line
1.8.3.1
Joel Stanley
maintainerQuoted 16 lines · On Wed, 29 Jul 2020 at 11:31, <[email protected]> wrote:
From: Vishwanatha Subbanna <[email protected]>
These are LEDs that are controlled by 9551
Signed-off-by Vishwanatha Subbanna <[email protected]>Reviewed-by Eddie James <[email protected]>--- arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts | 82 ++++++++++++++++++++++++++++ 1 file changed, 82 insertions(+)arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts +0
-0
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts line 128
Quoted 9 lines
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts +6
-0@@ -120,6 +120,38 @@ reg = <3>; }; }; + + leds { + compatible = "gpio-leds"; + + /* System ID LED that is at front on Op Panel */ + front-sys-id0 {
The naming here will need to follow whatever we decide in the first patch.
Quoted 30 lines
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts +26
-0+ retain-state-shutdown; + default-state = "keep"; + gpios = <&pca1 0 GPIO_ACTIVE_LOW>; + }; + + /* System Attention Indicator ID LED that is at front on Op Panel */ + front-check-log0 { + retain-state-shutdown; + default-state = "keep"; + gpios = <&pca1 1 GPIO_ACTIVE_LOW>; + }; + + /* Enclosure Fault LED that is at front on Op Panel */ + front-enc-fault1 { + retain-state-shutdown; + default-state = "keep"; + gpios = <&pca1 2 GPIO_ACTIVE_LOW>; + }; + + /* System PowerOn LED that is at front on Op Panel */ + front-sys-pwron0 { + retain-state-shutdown; + default-state = "keep"; + gpios = <&pca1 3 GPIO_ACTIVE_LOW>; + }; + }; }; &ehci1 {
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts line 851
Quoted 4 lines
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts +1
-0@@ -816,6 +848,56 @@ }; }; + pca1: pca9551@60 {
I noticed we start to accumulate a lot of pcaX nodes. They will need to be unique per-device tree, so we will need to pick a unique identifier.
How about the part number the schematic? (ie U32 or whatever)
Quoted 55 lines
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts +49
-1+ compatible = "nxp,pca9551"; + reg = <0x60>; + #address-cells = <1>; + #size-cells = <0>; + + gpio-controller; + #gpio-cells = <2>; + + gpio@0 { + reg = <0>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@1 { + reg = <1>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@2 { + reg = <2>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@3 { + reg = <3>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@4 { + reg = <4>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@5 { + reg = <5>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@6 { + reg = <6>; + type = <PCA955X_TYPE_GPIO>; + }; + + gpio@7 { + reg = <7>; + type = <PCA955X_TYPE_GPIO>; + }; + }; + dps: dps310@76 { compatible = "infineon,dps310"; reg = <0x76>; --1.8.3.1