Skip to contentSkip to conversation

scsi: ufs: Fix ufs power down/on specs violation

RFC PATCH Superseded Ziqi Chen 1 participant 1 message Dec 21, 2020

Subsystems (3)

v2 of 6 Superseded Latest is v6 →

lore
Share & tools
lore

Ziqi Chen

author
#0 lore raw

RFC PATCH v2 1/1 scsi: ufs: Fix ufs power down/on specs violation

As per specs, e.g, JESD220E chapter 7.2, while powering off/on the ufs device, RST_N signal and REF_CLK signal should be between VSS(Ground) and VCCQ/VCCQ2.

To flexibly control device reset line, re-name the function ufschd_vops_device_reset(sturct ufs_hba *hba) to ufshcd_ vops_toggle_device_reset(sturct ufs_hba *hba, bool up). The new parameter "bool up" is used to separate device reset line pulling up from pulling down.

Cc Kiwoong Kim <[email protected]>
Cc Stanley Chu <[email protected]>
---
 drivers/scsi/ufs/ufs-mediatek.c | 27 +++++++++-----------------
 drivers/scsi/ufs/ufs-qcom.c     | 22 ++++++++++-----------
 drivers/scsi/ufs/ufshcd.c       | 43 ++++++++++++++++++++++++++++++-----------
 drivers/scsi/ufs/ufshcd.h       | 10 +++++-----
 4 files changed, 56 insertions(+), 46 deletions(-)
drivers/scsi/ufs/ufs-mediatek.c +9 -18
index 80618af..bff2c42 100644
@@ -841,27 +841,18 @@ static int ufs_mtk_link_startup_notify(struct ufs_hba *hba,
 	return ret;
 }
 
-static int ufs_mtk_device_reset(struct ufs_hba *hba)
+static int ufs_mtk_toggle_device_reset(struct ufs_hba *hba, bool down)
 {
 	struct arm_smccc_res res;
 
-	ufs_mtk_device_reset_ctrl(0, res);
-
-	/*
-	 * The reset signal is active low. UFS devices shall detect
-	 * more than or equal to 1us of positive or negative RST_n
-	 * pulse width.
-	 *
-	 * To be on safe side, keep the reset low for at least 10us.
-	 */
-	usleep_range(10, 15);
-
-	ufs_mtk_device_reset_ctrl(1, res);
-
-	/* Some devices may need time to respond to rst_n */
-	usleep_range(10000, 15000);
+	if (down) {
+		ufs_mtk_device_reset_ctrl(0, res);
+	} else {
+		ufs_mtk_device_reset_ctrl(1, res);
 
-	dev_info(hba->dev, "device reset done\n");
+		/* Some devices may need time to respond to rst_n */
+		usleep_range(10000, 15000);
+	}
 
 	return 0;
 }
@@ -1052,7 +1043,7 @@ static const struct ufs_hba_variant_ops ufs_hba_mtk_vops = {
 	.suspend             = ufs_mtk_suspend,
 	.resume              = ufs_mtk_resume,
 	.dbg_register_dump   = ufs_mtk_dbg_register_dump,
-	.device_reset        = ufs_mtk_device_reset,
+	.toggle_device_reset        = ufs_mtk_toggle_device_reset,
 	.event_notify        = ufs_mtk_event_notify,
 };
 
drivers/scsi/ufs/ufs-qcom.c +10 -12
index 2206b1e..c2ccaa5 100644
@@ -1404,12 +1404,13 @@ static void ufs_qcom_dump_dbg_regs(struct ufs_hba *hba)
 }
 
 /**
- * ufs_qcom_device_reset() - toggle the (optional) device reset line
+ * ufs_qcom_toggle_device_reset() - toggle the (optional) device reset line
  * @hba: per-adapter instance
+ * @down: pull down or pull up device reset line
  *
  * Toggles the (optional) reset line to reset the attached device.
  */
-static int ufs_qcom_device_reset(struct ufs_hba *hba)
+static int ufs_qcom_toggle_device_reset(struct ufs_hba *hba, bool down)
 {
 	struct ufs_qcom_host *host = ufshcd_get_variant(hba);
 
@@ -1417,15 +1418,12 @@ static int ufs_qcom_device_reset(struct ufs_hba *hba)
 	if (!host->device_reset)
 		return -EOPNOTSUPP;
 
-	/*
-	 * The UFS device shall detect reset pulses of 1us, sleep for 10us to
-	 * be on the safe side.
-	 */
-	gpiod_set_value_cansleep(host->device_reset, 1);
-	usleep_range(10, 15);
-
-	gpiod_set_value_cansleep(host->device_reset, 0);
-	usleep_range(10, 15);
+	if (down) {
+		gpiod_set_value_cansleep(host->device_reset, 1);
+	} else {
+		gpiod_set_value_cansleep(host->device_reset, 0);
+		usleep_range(10, 15);
+	}
 
 	return 0;
 }
@@ -1473,7 +1471,7 @@ static const struct ufs_hba_variant_ops ufs_hba_qcom_vops = {
 	.suspend		= ufs_qcom_suspend,
 	.resume			= ufs_qcom_resume,
 	.dbg_register_dump	= ufs_qcom_dump_dbg_regs,
-	.device_reset		= ufs_qcom_device_reset,
+	.toggle_device_reset		= ufs_qcom_toggle_device_reset,
 	.config_scaling_param = ufs_qcom_config_scaling_param,
 	.program_key		= ufs_qcom_ice_program_key,
 };
drivers/scsi/ufs/ufshcd.c +32 -11

105 lines not on this page · raw message

drivers/scsi/ufs/ufshcd.h +5 -5
index 9bb5f0e..dccc3eb 100644
@@ -319,7 +319,7 @@ struct ufs_pwr_mode_info {
  * @resume: called during host controller PM callback
  * @dbg_register_dump: used to dump controller debug information
  * @phy_initialization: used to initialize phys
- * @device_reset: called to issue a reset pulse on the UFS device
+ * @toggle_device_reset: called to change logic level of reset gpio on the UFS device
  * @program_key: program or evict an inline encryption key
  * @event_notify: called to notify important events
  */
@@ -350,7 +350,7 @@ struct ufs_hba_variant_ops {
 	int     (*resume)(struct ufs_hba *, enum ufs_pm_op);
 	void	(*dbg_register_dump)(struct ufs_hba *hba);
 	int	(*phy_initialization)(struct ufs_hba *);
-	int	(*device_reset)(struct ufs_hba *hba);
+	int	(*toggle_device_reset)(struct ufs_hba *hba, bool down);
 	void	(*config_scaling_param)(struct ufs_hba *hba,
 					struct devfreq_dev_profile *profile,
 					void *data);
@@ -1216,10 +1216,10 @@ static inline void ufshcd_vops_dbg_register_dump(struct ufs_hba *hba)
 		hba->vops->dbg_register_dump(hba);
 }
 
-static inline int ufshcd_vops_device_reset(struct ufs_hba *hba)
+static inline int ufshcd_vops_toggle_device_reset(struct ufs_hba *hba, bool down)
 {
-	if (hba->vops && hba->vops->device_reset)
-		return hba->vops->device_reset(hba);
+	if (hba->vops && hba->vops->toggle_device_reset)
+		return hba->vops->toggle_device_reset(hba, down);
 
 	return -EOPNOTSUPP;
 }
Signature · 8 lines
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project


_______________________________________________
Linux-mediatek mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-mediatek