Skip to contentSkip to conversation

dt: bindings: add new DT entry for ath11k PCI device support

PATCH Superseded Anilkumar Kolli 2 participants 4 messages Nov 23, 2021 – Nov 25, 2021

Subsystems (3)

v5 of 7 Superseded Latest is v7 →

lore
Share & tools
lore
#0 lore raw

PATCH v5 1/2 dt: bindings: add new DT entry for ath11k PCI device support

Ath11k driver supports PCI devices such as QCN9074/QCA6390. Ath11k firmware uses host DDR memory, DT entry is used to reserve host DDR memory regions, send these memory base addresses using DT entries.

---
V4:
- Fix dt_binding_check warnings (Rob)
V2:
- Use reserved-memory (Rob)

 .../bindings/net/wireless/qcom,ath11k.yaml         | 30 ++++++++++++++++++++++
 1 file changed, 30 insertions(+)
Documentation/devicetree/bindings/net/wireless/qcom,ath11k.yaml +30 -0
index 85c2f699d602..cdf7b873b419 100644
@@ -150,6 +150,12 @@ properties:
       string to uniquely identify variant of the calibration data in the
       board-2.bin for designs with colliding bus and device specific ids
 
+  memory-region:
+    maxItems: 1
+    description:
+      phandle to a node describing reserved memory (System RAM memory)
+      used by ath11k firmware (see bindings/reserved-memory/reserved-memory.txt)
+
 required:
   - compatible
   - reg
@@ -279,3 +285,27 @@ examples:
                           "tcl2host-status-ring";
         qcom,rproc = <&q6v5_wcss>;
     };
+
+  - |
+
+    reserved-memory {
+        #address-cells = <2>;
+        #size-cells = <2>;
+
+        qcn9074_0: qcn9074_0@51100000 {
+            no-map;
+            reg = <0x0 0x51100000 0x0 0x03500000>;
+        };
+    };
+
+    pci {
+        pcie0 {
+            #size-cells = <2>;
+            #address-cells = <3>;
+ 
+            wifi_0: wifi@0 {
+                reg = <0 0 0 0 0>;
+                memory-region = <&qcn9074_0>;
+            };
+        };
+    };
Signature · 1 line
2.7.4
#1 lore raw

PATCH v5 2/2 ath11k: Use reserved host DDR addresses from DT for PCI devices

Host DDR memory (contiguous 45 MB in mode-0 or 15 MB in mode-2) is reserved through DT entries for firmware usage. Send the base address from DT entries.
If DT entry is available, PCI device will work with fixed_mem_region else host allocates multiple segments.

IPQ8074 on HK10 board supports multiple PCI devices. IPQ8074 + QCN9074 is tested with this patch.

Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.4.0.1-01838-QCAHKSWPL_SILICONZ-1

---
V5:
- Use of_address_to_resource() (Sven)
V4:
- Update code review comments to handle return (Kalle)
V3:
- remove type cast and use of_property_read_u32_array() (Kalle)
V2:
- Use of_ API to read from dt node (Rob)

 drivers/net/wireless/ath/ath11k/core.h |  1 +
 drivers/net/wireless/ath/ath11k/mhi.c  | 34 ++++++++++++++-
 drivers/net/wireless/ath/ath11k/pci.c  | 11 ++++-
 drivers/net/wireless/ath/ath11k/qmi.c  | 76 +++++++++++++++++++++++++++++-----
 drivers/net/wireless/ath/ath11k/qmi.h  |  1 +
 5 files changed, 110 insertions(+), 13 deletions(-)
drivers/net/wireless/ath/ath11k/core.h +1 -0
index 2f1e10b7cc17..8492ca7efb92 100644
@@ -194,6 +194,7 @@ enum ath11k_dev_flags {
 	ATH11K_FLAG_REGISTERED,
 	ATH11K_FLAG_QMI_FAIL,
 	ATH11K_FLAG_HTC_SUSPEND_COMPLETE,
+	ATH11K_FLAG_FIXED_MEM_RGN,
 };
 
 enum ath11k_monitor_flags {
drivers/net/wireless/ath/ath11k/mhi.c +32 -2
index 26c7ae242db6..b6003406e2a1 100644
@@ -3,6 +3,9 @@
 
 #include <linux/msi.h>
 #include <linux/pci.h>
+#include <linux/of.h>
+#include <linux/of_address.h>
+#include <linux/ioport.h>
 
 #include "core.h"
 #include "debug.h"
@@ -311,6 +314,26 @@ static void ath11k_mhi_op_write_reg(struct mhi_controller *mhi_cntrl,
 	writel(val, addr);
 }
 
+static int ath11k_mhi_read_addr_from_dt(struct mhi_controller *mhi_ctrl)
+{
+	struct device_node *np;
+	struct resource res;
+	int ret;
+
+	np = of_find_node_by_type(NULL, "memory");
+	if (!np)
+		return -ENOENT;
+
+	ret = of_address_to_resource(np, 0, &res);
+	if (ret)
+		return ret;
+
+	mhi_ctrl->iova_start = res.start + 0x1000000;
+	mhi_ctrl->iova_stop = res.end;
+
+	return 0;
+}
+
 int ath11k_mhi_register(struct ath11k_pci *ab_pci)
 {
 	struct ath11k_base *ab = ab_pci->ab;
@@ -339,8 +362,15 @@ int ath11k_mhi_register(struct ath11k_pci *ab_pci)
 		return ret;
 	}
 
-	mhi_ctrl->iova_start = 0;
-	mhi_ctrl->iova_stop = 0xffffffff;
+	if ((test_bit(ATH11K_FLAG_FIXED_MEM_RGN, &ab->dev_flags))) {
+		ret = ath11k_mhi_read_addr_from_dt(mhi_ctrl);
+		if (ret < 0)
+			return ret;
+	} else {
+		mhi_ctrl->iova_start = 0;
+		mhi_ctrl->iova_stop = 0xFFFFFFFF;
+	}
+
 	mhi_ctrl->sbl_size = SZ_512K;
 	mhi_ctrl->seg_len = SZ_512K;
 	mhi_ctrl->fbc_download = true;
drivers/net/wireless/ath/ath11k/pci.c +10 -1
index 3d353e7c9d5c..e12d9753f113 100644
@@ -6,6 +6,7 @@
 #include <linux/module.h>
 #include <linux/msi.h>
 #include <linux/pci.h>
+#include <linux/of.h>
 
 #include "pci.h"
 #include "core.h"
@@ -1225,7 +1226,7 @@ static int ath11k_pci_probe(struct pci_dev *pdev,
 {
 	struct ath11k_base *ab;
 	struct ath11k_pci *ab_pci;
-	u32 soc_hw_version_major, soc_hw_version_minor;
+	u32 soc_hw_version_major, soc_hw_version_minor, addr;
 	int ret;
 
 	ab = ath11k_core_alloc(&pdev->dev, sizeof(*ab_pci), ATH11K_BUS_PCI,
@@ -1245,6 +1246,14 @@ static int ath11k_pci_probe(struct pci_dev *pdev,
 	pci_set_drvdata(pdev, ab);
 	spin_lock_init(&ab_pci->window_lock);
 
+	/* Set fixed_mem_region to true for platforms support reserved memory
+	 * from DT. If memory is reserved from DT for FW, ath11k driver need not
+	 * allocate memory.
+	 */
+	ret = of_property_read_u32(ab->dev->of_node, "memory-region", &addr);
+	if (!ret)
+		set_bit(ATH11K_FLAG_FIXED_MEM_RGN, &ab->dev_flags);
+
 	ret = ath11k_pci_claim(ab_pci, pdev);
 	if (ret) {
 		ath11k_err(ab, "failed to claim device: %d\n", ret);
drivers/net/wireless/ath/ath11k/qmi.c +66 -10

116 lines not on this page · raw message

drivers/net/wireless/ath/ath11k/qmi.h +1 -0
index 3bb0f9ef7996..f8d45b7dc821 100644
@@ -95,6 +95,7 @@ struct target_mem_chunk {
 	u32 type;
 	dma_addr_t paddr;
 	u32 *vaddr;
+	void __iomem *iaddr;
 };
 
 struct target_info {
Signature · 1 line
2.7.4
#2 lore raw

Re: [PATCH v5 2/2] ath11k: Use reserved host DDR addresses from DT for PCI devices

Quoted 4 lines · On Tuesday, 23 November 2021 12:29:00 CET Anilkumar Kolli wrote:
drivers/net/wireless/ath/ath11k/qmi.c +4 -0
+                       ret = of_property_read_u32(dev->of_node, "memory-region",
+                                                  &hremote_phandle);
+                       if (ret) {
+                               ath11k_dbg(ab, ATH11K_DBG_QMI,

drivers/net/wireless/ath/ath11k/qmi.c static int ath11k_qmi_alloc_target_mem_chunk(struct ath11k_base *ab) · line 1898

Quoted 10 lines
drivers/net/wireless/ath/ath11k/qmi.c +10 -0
+                                          "qmi fail to get hremote phandle\n");
+                               return ret;
+                       }
+
+                       hremote_node = of_find_node_by_phandle(hremote_phandle);
+                       if (!hremote_node) {
+                               ath11k_dbg(ab, ATH11K_DBG_QMI,
+                                          "qmi fail to get hremote_node\n");
+                               return ret;
+                       }

Afaik, this can be combined via

    hremote_node = of_parse_phandle(dev->of_node, "memory-region", 0);

Kind regards,
Sven

#3 lore raw

Re: [PATCH v5 2/2] ath11k: Use reserved host DDR addresses from DT for PCI devices

Quoted 20 lines · Sven Eckelmann
Quoted 16 lines · On Tuesday, 23 November 2021 12:29:00 CET Anilkumar Kolli wrote:

+ ret = of_property_read_u32(dev->of_node,
"memory-region",

drivers/net/wireless/ath/ath11k/qmi.c +4 -0
+                                                  &hremote_phandle);
+                       if (ret) {
+                               ath11k_dbg(ab, ATH11K_DBG_QMI,
+                                          "qmi fail to get hremote 

phandle\n");

drivers/net/wireless/ath/ath11k/mhi.c +4 -0
+                               return ret;
+                       }
+
+                       hremote_node = 

of_find_node_by_phandle(hremote_phandle);

drivers/net/wireless/ath/ath11k/qmi.c +3 -0
+                       if (!hremote_node) {
+                               ath11k_dbg(ab, ATH11K_DBG_QMI,
+                                          "qmi fail to get 

hremote_node\n");

Review

Quoted 2 lines
(quoted diff) +2 -0
+                               return ret;
+                       }
Quoted 4 lines

Afaik, this can be combined via

    hremote_node = of_parse_phandle(dev->of_node, "memory-region", 0);

Yes Sven, I will update in next version.

Thanks
Anil.

Signature · 3 lines
ath11k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath11k