FAILED: patch "[PATCH] mtd: core: Fix a conflict between MTD and NVMEM on wp-gpios" failed to apply to 5.10-stable tree

The patch below does not apply to the 5.10-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.

thanks,

greg k-h

------------------ original commit in Linus's tree ------------------

From 6c7621890995d089a56a06d11580d185ede7c2f8 Mon Sep 17 00:00:00 2001
From: Christophe Kerello <[email protected]>
Date: Sun, 20 Feb 2022 15:14:32 +0000
Subject: [PATCH] mtd: core: Fix a conflict between MTD and NVMEM on wp-gpios
property

Wp-gpios property can be used on NVMEM nodes and the same property can be also used on MTD NAND nodes. In case of the wp-gpios property is defined at NAND level node, the GPIO management is done at NAND driver level. Write protect is disabled when the driver is probed or resumed and is enabled when the driver is released or suspended.

When no partitions are defined in the NAND DT node, then the NAND DT node will be passed to NVMEM framework. If wp-gpios property is defined in this node, the GPIO resource is taken twice and the NAND controller driver fails to probe.

A new Boolean flag named ignore_wp has been added in nvmem_config. In case ignore_wp is set, it means that the GPIO is handled by the provider. Lets set this flag in MTD layer to avoid the conflict on wp_gpios property.

index 70f492dce158..eef87b28d6c8 100644
@@ -546,6 +546,7 @@ static int mtd_nvmem_add(struct mtd_info *mtd)
 	config.stride = 1;
 	config.read_only = true;
 	config.root_only = true;
+	config.ignore_wp = true;
 	config.no_of_node = !of_device_is_compatible(node, "nvmem-cells");
 	config.priv = mtd;
 

@@ -833,6 +834,7 @@ static struct nvmem_device *mtd_otp_nvmem_register(struct mtd_info *mtd,
 	config.owner = THIS_MODULE;
 	config.type = NVMEM_TYPE_OTP;
 	config.root_only = true;
+	config.ignore_wp = true;
 	config.reg_read = reg_read;
 	config.size = size;
 	config.of_node = np;