Skip to contentSkip to conversation

mlxbf_gige: increase MDIO polling rate to 5us

PATCH Applied David Thompson 2 participants 2 messages May 5, 2022 – May 7, 2022

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 mlxbf_gige: increase MDIO polling rate to 5us

This patch increases the polling rate used by the mlxbf_gige driver on the MDIO bus. The previous polling rate was every 100us, and the new rate is every 5us. With this change the amount of time spent waiting for the MDIO BUSY signal to de-assert drops from ~100us to ~27us for each operation.

---
 drivers/net/ethernet/mellanox/mlxbf_gige/mlxbf_gige_mdio.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)
drivers/net/ethernet/mellanox/mlxbf_gige/mlxbf_gige_mdio.c +4 -2
index 7905179a9575..2e6c1b7af096 100644
@@ -105,7 +105,8 @@ static int mlxbf_gige_mdio_read(struct mii_bus *bus, int phy_add, int phy_reg)
 	writel(cmd, priv->mdio_io + MLXBF_GIGE_MDIO_GW_OFFSET);
 
 	ret = readl_poll_timeout_atomic(priv->mdio_io + MLXBF_GIGE_MDIO_GW_OFFSET,
-					val, !(val & MLXBF_GIGE_MDIO_GW_BUSY_MASK), 100, 1000000);
+					val, !(val & MLXBF_GIGE_MDIO_GW_BUSY_MASK),
+					5, 1000000);
 
 	if (ret) {
 		writel(0, priv->mdio_io + MLXBF_GIGE_MDIO_GW_OFFSET);
@@ -137,7 +138,8 @@ static int mlxbf_gige_mdio_write(struct mii_bus *bus, int phy_add,
 
 	/* If the poll timed out, drop the request */
 	ret = readl_poll_timeout_atomic(priv->mdio_io + MLXBF_GIGE_MDIO_GW_OFFSET,
-					temp, !(temp & MLXBF_GIGE_MDIO_GW_BUSY_MASK), 100, 1000000);
+					temp, !(temp & MLXBF_GIGE_MDIO_GW_BUSY_MASK),
+					5, 1000000);
 
 	return ret;
 }
Signature · 1 line
2.30.1
#1 lore raw
This patch was applied to netdev/net-next.git (master) by Jakub Kicinski <[email protected]>:

Hello:

This patch was applied to netdev/net-next.git (master) by Jakub Kicinski <[email protected]>:

Quoted 8 lines · On Thu, 5 May 2022 12:23:09 -0400 you wrote:

This patch increases the polling rate used by the mlxbf_gige driver on the MDIO bus. The previous polling rate was every 100us, and the new rate is every 5us. With this change the amount of time spent waiting for the MDIO BUSY signal to de-assert drops from ~100us to ~27us for each operation.

[...]

Here is the summary with links:
- [net-next,v1] mlxbf_gige: increase MDIO polling rate to 5us

    https://git.kernel.org/netdev/net-next/c/0a02e282bad4

You are awesome, thank you!

Signature · 2 lines
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html