net/qla3xxx: Fix a test in ql_reset_work()

test_bit() tests if one bit is set or not.
Here the logic seems to check of bit QL_RESET_PER_SCSI (i.e. 4) OR bit QL_RESET_START (i.e. 3) is set.

In fact, it checks if bit 7 (4 | 3 = 7) is set, that is to say QL_ADAPTER_UP.

This looks harmless, because this bit is likely be set, and when the ql_reset_work() delayed work is scheduled in ql3xxx_isr() (the only place that schedule this work), QL_RESET_START or QL_RESET_PER_SCSI is set.

This has been spotted by smatch.

---
This patch is speculative and should certainly be tested by s.o. with the needed hardware.

Maybe, the whole 'if (test_bit(...)' test should be removed because it is always true. If it is really the case, this would save 1 level of indentation.

---
 drivers/net/ethernet/qlogic/qla3xxx.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

index b30589a135c2..70241faaa841 100644
@@ -3614,7 +3614,8 @@ static void ql_reset_work(struct work_struct *work)
 		qdev->mem_map_registers;
 	unsigned long hw_flags;
 
-	if (test_bit((QL_RESET_PER_SCSI | QL_RESET_START), &qdev->flags)) {
+	if (test_bit((QL_RESET_PER_SCSI), &qdev->flags) ||
+	    test_bit((QL_RESET_START), &qdev->flags)) {
 		clear_bit(QL_LINK_MASTER, &qdev->flags);
 
 		/*

2.34.1